kopia lustrzana https://github.com/meshtastic/firmware
42 wiersze
2.1 KiB
Markdown
42 wiersze
2.1 KiB
Markdown
|
|
|
|
# High priority
|
|
|
|
* solder debug headers to board - debug sendTo hang bug
|
|
* make message send from android go to service, then to mesh radio
|
|
* make message receive from radio go through to android
|
|
* have MeshService keep a node DB by sniffing user messages
|
|
* have meshservice send location data on mesh (if device has a GPS)
|
|
|
|
# Medium priority
|
|
|
|
* use https://lastminuteengineers.com/esp32-sleep-modes-power-consumption/ association sleep pattern to save power - but see https://github.com/espressif/esp-idf/issues/2070
|
|
* correctly map nodeids to nodenums, currently we just do a proof of concept by always doing a broadcast
|
|
* add interrupt detach/sleep mode config to lora radio so we can enable deepsleep without panicing
|
|
* figure out if we can use PA_BOOST
|
|
* scrub default radio config settings for bandwidth/range/speed
|
|
* use a freertos thread to remain blocked reading from recvfromAckTimeout, so that we don't need to keep polling it from our main thread
|
|
* override peekAtMessage so we can see any messages that pass through our node (even if not broadcast)? would that be useful?
|
|
* sendToMesh can currently block for a long time, instead have it just queue a packet for a radio freertos thread
|
|
* see section 7.3 of https://cdn.sparkfun.com/assets/learn_tutorials/8/0/4/RFM95_96_97_98W.pdf and have hope radio wake only when a valid packet is received. Possibly even wake the ESP32 from deep sleep via GPIO.
|
|
* fix the logo
|
|
|
|
# Pre-beta priority
|
|
|
|
* do hibernation mode to get power draw down to 2.5uA https://lastminuteengineers.com/esp32-sleep-modes-power-consumption/
|
|
* make sure main cpu is not woken for packets with bad crc or not addressed to this node - do that in the radio hw
|
|
* enable fast init inside the gps chip
|
|
* dynamically select node nums
|
|
* triple check fcc compliance
|
|
* allow setting full radio params from android
|
|
|
|
# Low priority
|
|
|
|
* report esp32 device code bugs back to the mothership via android
|
|
|
|
# Done
|
|
|
|
* change the partition table to take advantage of the 4MB flash on the wroom: http://docs.platformio.org/en/latest/platforms/espressif32.html#partition-tables
|
|
* wrap in nice MeshRadio class
|
|
* add mesh send & rx
|