meshtastic-firmware/TODO.md

High priority

• solder debug headers to board - debug sendTo hang bug
• make message send from android go to service, then to mesh radio
• make message receive from radio go through to android
• have MeshService keep a node DB by sniffing user messages
• have meshservice send location data on mesh (if device has a GPS)

Medium priority

• use https://lastminuteengineers.com/esp32-sleep-modes-power-consumption/ association sleep pattern to save power - but see https://github.com/espressif/esp-idf/issues/2070
• correctly map nodeids to nodenums, currently we just do a proof of concept by always doing a broadcast
• add interrupt detach/sleep mode config to lora radio so we can enable deepsleep without panicing
• figure out if we can use PA_BOOST
• scrub default radio config settings for bandwidth/range/speed
• use a freertos thread to remain blocked reading from recvfromAckTimeout, so that we don't need to keep polling it from our main thread
• override peekAtMessage so we can see any messages that pass through our node (even if not broadcast)? would that be useful?
• sendToMesh can currently block for a long time, instead have it just queue a packet for a radio freertos thread
• see section 7.3 of https://cdn.sparkfun.com/assets/learn_tutorials/8/0/4/RFM95_96_97_98W.pdf and have hope radio wake only when a valid packet is received. Possibly even wake the ESP32 from deep sleep via GPIO.
• fix the logo

Pre-beta priority

• do hibernation mode to get power draw down to 2.5uA https://lastminuteengineers.com/esp32-sleep-modes-power-consumption/
• make sure main cpu is not woken for packets with bad crc or not addressed to this node - do that in the radio hw
• enable fast init inside the gps chip
• dynamically select node nums
• triple check fcc compliance
• allow setting full radio params from android

Low priority

• report esp32 device code bugs back to the mothership via android

Done

• change the partition table to take advantage of the 4MB flash on the wroom: http://docs.platformio.org/en/latest/platforms/espressif32.html#partition-tables
• wrap in nice MeshRadio class
• add mesh send & rx