esp32_loraprs

It is possible to use modem in client mode with other generic Linux AX25/APRS tools on PC or Raspberry, such as Xastir, use next procedure to set it up:

AX25 howto: http://tldp.org/HOWTO/AX25-HOWTO/
Install required tools: sudo apt-get install ax25-tools ax25-apps xastir bluez bluez-tools
If you are using USB mode then /dev/ttyUSBx port should appear on connection
If you are using Bluetooth mode then you need to pair and create virtual port with rfcomm
- Run bluetoothctl and pair with the modem:
```
# bluetoothctl
[bluetooth]# agent on
[bluetooth]# default-agent
[NEW] Device 01:02:03:04:05:06 loraprs
[bluetooth]# pair 01:02:03:04:05:06
Attempting to pair with 01:02:03:04:05:06
Pairing successful
[bluetooth]# exit
```
- Run rfcomm to setup serial over Bluetooth at /dev/rfcomm0: sudo rfcomm bind 0 01:02:03:04:05:06
At this stage you can already start using xastir or any other application, which can operate over KISS Serial TNC
You can setup AX25 network interface with sudo kissattach /dev/rfcomm0 ax25 command, but previously need to update /etc/ax25/axports with new line as ax25 CALLSIGN-10 9600 255 1 comment, you can also specify IP address if there is a need to run TCP/IP over AX25
Run axlisten to capture incoming and outgoing traffic as sudo axlisten -a

Use beacon utility to send custom packet as

# sudo beacon -s -c NOCALL-7 -d "BEACON WIDE3-3" ax25 "beacon over lora"
# sudo beacon -s -c NOCALL-7 -d "CQ WIDE1-1 WIDE2-1" ax25 "anyone on lora?"
# sudo beacon -s -c NOCALL-7 -d "APZMDM WIDE1-1" ax25 "!0000.00N/00000.00E#test position report"

Connect to another client as sudo axcall -s NOCALL-1 ax25 NOCALL-10