Minimalistic Android KISS Bluetooth/USB modem client for Amateur Radio DV (digital voice) communication by using open source [Codec2](https://github.com/drowe67/codec2).
This minimalistic Android application is a digital voice frontend for your radio. It connects to your radio KISS Bluetooth/USB modem, sends and receives Codec2 audio frames, which are encapsulated inside KISS frames. It does not deal with radio management, modulation, etc, it is up to your modem and radio, it could be just AFSK1200, GMSK 9600, LoRa, FSK, FreeDV or any other modulation scheme. Radio just needs to expose KISS Bluetooth interface for speech frames.
- KISS support is not 100% necesssary for experiments, usually radio module needs to decide on protocol, but KISS frames could be sent over aether, there are plans to add support for other selectable frame structures, protocols or raw audio frames
- **USB serial connectivity** (default 115200 bps, 8 data bits, 1 stop bit, no parity), just select this app after connecting to USB and it will use given connection, baud rate could be changed from Preferences
- **Bluetooth connectivity** on startup, lists paired devices, so you can choose your modem and connect, you need to pair with your Bluetooth device first from Android Bluetooth Settings, default Bluetooth device could be set from Preferences
- **Voice codec2 mode selection**, which allows you to select various codec2 modes from 450 up to 3200 bps on the fly, sender and receiver should agree on the codec mode and use the same codec mode on both ends as codec2 mode negotiation between clients is not implemented at the moment
- **Codec2 loopback mode**, which records and plays your recorded voice back to test and evaluate different Codec2 modes and speech quality, could be enabled or disabled from Preferences, this mode is activated if no USB or Bluetooth connection were made
- (BT) custom AFSK1200 LibAPRS based modem with increased TXTail parameter and Baofeng handheld transceiver: 450 works fine, 700 works with small gaps, probably LibAPRS needs some tweaks: https://github.com/markqvist/LibAPRS
- (USB) HC-12 modules: works, but application needs to use lower USB serial bit rate (change from Preferences), because module RF bit rate is hardwired to its serial bit rate, also module needs to be preconfigured with AT commands first
- most likely you do not have enough bandwidth, use higher throughput modem mode, for LoRa modems you need approximately 170% of data rate for the given codec2 bitrate, AFSK1200 modems should work at 450 bps codec2 mode, 700 bps might work, but not on all modems, higher speed codec2 modes won't work on AFSK1200
- modem goes into RX state too fast after sending first packet, increase TxTail parameter for your modem if it does not handle corresponding KISS command, so it will stay longer in TX before switching to RX
- if you are using LibAPRS based modem, set TxTail and TxPreamble programatically by using `APRS_setPreamble` and `APRS_setTail` methods as it does not seem to set these values from `CMD_TXDELAY` and `CMD_TXTAIL` KISS commands
- Modem profiles, so different modems could be controlled from the UI with KISS command extensions, so that user can change frequency/channel, modulation scheme, modem speed or other modem parameters on the fly from the user interface
- Rig/radio module control and signal level reports by using KISS command extensions
