sforkowany z mirror/meshtastic-firmware
42 wiersze
1.7 KiB
C
42 wiersze
1.7 KiB
C
// #define BUTTON_NEED_PULLUP // if set we need to turn on the internal CPU pullup during sleep
|
|
|
|
#define I2C_SDA 21
|
|
#define I2C_SCL 22
|
|
|
|
#define BUTTON_PIN 36 // The middle button GPIO on the Nano G1
|
|
//#define BUTTON_PIN_ALT 13 // Alternate GPIO for an external button if needed. Does anyone use this? It is not documented anywhere.
|
|
#define EXT_NOTIFY_OUT 13 // Default pin to use for Ext Notify Module.
|
|
|
|
// common pinout for their SX1262 vs RF95 modules - both can be enabled and we will probe at runtime for RF95 and if
|
|
// not found then probe for SX1262
|
|
#define USE_RF95
|
|
#define USE_SX1262
|
|
|
|
#define LORA_DIO0 26 // a No connect on the SX1262 module
|
|
#define LORA_RESET 23
|
|
#define LORA_DIO1 33 // SX1262 IRQ
|
|
#define LORA_DIO2 32 // SX1262 BUSY
|
|
#define LORA_DIO3 // Not connected on PCB
|
|
|
|
#ifdef USE_SX1262
|
|
#define SX126X_CS RF95_NSS // FIXME - we really should define LORA_CS instead
|
|
#define SX126X_DIO1 LORA_DIO1
|
|
#define SX126X_BUSY LORA_DIO2
|
|
#define SX126X_RESET LORA_RESET
|
|
//#define SX126X_E22 // Not really an E22
|
|
// Internally the module hooks the SX1262-DIO2 in to control the TX/RX switch (which is the default for the sx1262interface
|
|
// code)
|
|
#define SX126X_MAX_POWER 16 //Ensure the PA does not exceed the saturation output power. More Info:https://uniteng.com/wiki/doku.php?id=meshtastic:station#rf_design_-_lora_station_edition_g1
|
|
#endif
|
|
|
|
#define BATTERY_PIN 35 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
|
|
#define BATTERY_SENSE_SAMPLES 30 //Set the number of samples, It has an effect of increasing sensitivity.
|
|
#define ADC_MULTIPLIER 6.45
|
|
#define BAT_FULLVOLT 12600
|
|
#define BAT_EMPTYVOLT 8200
|
|
#define BAT_CHARGINGVOLT 12600
|
|
#define BAT_NOBATVOLT 6690
|
|
|
|
// different screen
|
|
#define USE_SH1106
|