kopia lustrzana https://github.com/micropython/micropython
47 wiersze
1.5 KiB
Markdown
47 wiersze
1.5 KiB
Markdown
Program your board using the esptool.py program, found [here](https://github.com/espressif/esptool).
|
|
|
|
Your uPesy EDU ESP32 has an auto-reset circuit on it, so there is no need to put it into a
|
|
download mode first to erase or flash it.
|
|
|
|
If you are putting MicroPython on your board for the first time then you should
|
|
first erase the entire flash using:
|
|
|
|
### Linux
|
|
```bash
|
|
esptool.py --chip esp32 --port /dev/ttyUSB0 erase_flash
|
|
```
|
|
|
|
### Mac
|
|
```bash
|
|
esptool.py --chip esp32 --port /dev/tty.SLAB_USBtoUART erase_flash
|
|
```
|
|
|
|
### Windows
|
|
Change (X) to whatever COM port is being used by the board
|
|
```bash
|
|
esptool --chip esp32 --port COM(X) erase_flash
|
|
```
|
|
|
|
Now download the version of the firmware you would like to install from the options below,
|
|
then use the following command to program the firmware starting at address 0x1000,
|
|
remembering to replace `upesy-edu-esp32-micropython-firmware-version.bin` with the name of the
|
|
firmware you just downloaded:
|
|
|
|
From then on program the firmware starting at address 0x1000:
|
|
|
|
### Linux
|
|
```bash
|
|
esptool.py --chip esp32 --port /dev/ttyUSB0 --baud 921600 write_flash -z 0x1000 upesy-edu-esp32-micropython-firmware-version.bin
|
|
```
|
|
|
|
### Mac
|
|
```bash
|
|
esptool.py --chip esp32 --port /dev/tty.SLAB_USBtoUART --baud 921600 write_flash -z 0x1000 upesy-edu-esp32-micropython-firmware-version.bin
|
|
```
|
|
|
|
### Windows
|
|
Change (X) to whatever COM port is being used by the board
|
|
```bash
|
|
esptool --chip esp32 --port COM(X) --baud 921600 write_flash -z 0x1000 upesy-edu-esp32-micropython-firmware-version.bin
|
|
```
|