esp-idf/examples/peripherals/usb/tusb_sample_descriptor/README.md

2.1 KiB

Supported Targets ESP32-S2

TinyUSB Sample Descriptor

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This example is demonstrating how to set up ESP32-S2 chip to work as a Generic USB Device with a user-defined descriptor. You can specify a manufacturer, device's name, ID and other USB-devices parameters responsible for identification by host.

As a USB stack, a TinyUSB component is used.

How to use example

Hardware Required

  • Any board with the ESP32-S2 chip

Configure the project

There are two ways to set up a descriptor - using Menuconfig tool and in-code

In-code setting up

For the manual descriptor's configuration use the default example's settings and modify tusb_sample_descriptor.c according to your needs

Menuconfig

If you want to set up the desctiptor using Menuconfig UI:

  1. Execute in the terminal from the example's directory: idf.py menuconfig

  2. Turn off Set up a USB descriptor manually in code parameter at Example Configuration

  3. Folow to Component config -> TinyUSB -> Descriptor configuration for all available configurations.

Build and Flash

Build the project and flash it to the board, then run monitor tool to view serial output:

idf.py -p PORT flash monitor

(Replace PORT with the name of the serial port to use.)

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example Output

After the flashing you should see the output:

I (314) example: USB initialization
I (314) TUSB:descriptors_control: Setting of a descriptor:
.bDeviceClass       = 0
.bDeviceSubClass    = 0,
.bDeviceProtocol    = 0,
.bMaxPacketSize0    = 64,
.idVendor           = 0x0000303a,
.idProduct          = 0x00004000,
.bcdDevice          = 0x00000100,
.iManufacturer      = 0x01,
.iProduct           = 0x02,
.iSerialNumber      = 0x03,
.bNumConfigurations = 0x01

I (344) example: USB initialization DONE
I (354) example: USB task started