Repetier-Firmware
0.91
|
Go to the source code of this file.
Data Structures | |
class | PrintLine |
Defines | |
#define | FLAG_WARMUP 1 |
#define | FLAG_NOMINAL 2 |
#define | FLAG_DECELERATING 4 |
#define | FLAG_ACCELERATION_ENABLED 8 |
#define | FLAG_CHECK_ENDSTOPS 16 |
#define | FLAG_SKIP_ACCELERATING 32 |
#define | FLAG_SKIP_DEACCELERATING 64 |
#define | FLAG_BLOCKED 128 |
#define | FLAG_JOIN_STEPPARAMS_COMPUTED 1 |
#define | FLAG_JOIN_END_FIXED 2 |
#define | FLAG_JOIN_START_FIXED 4 |
#define | FLAG_JOIN_START_RETRACT 8 |
#define | FLAG_JOIN_END_RETRACT 16 |
#define | FLAG_JOIN_NO_RETRACT 32 |
#define | FLAG_JOIN_WAIT_EXTRUDER_UP 64 |
#define | FLAG_JOIN_WAIT_EXTRUDER_DOWN 128 |
#define FLAG_ACCELERATION_ENABLED 8 |
#define FLAG_BLOCKED 128 |
#define FLAG_CHECK_ENDSTOPS 16 |
#define FLAG_DECELERATING 4 |
#define FLAG_JOIN_END_FIXED 2 |
The right speed is fixed. Don't check this block or any block to the left.
#define FLAG_JOIN_END_RETRACT 16 |
Wait for filament pushback, before ending move
#define FLAG_JOIN_NO_RETRACT 32 |
Disable retract for this line
#define FLAG_JOIN_START_FIXED 4 |
The left speed is fixed. Don't check left block.
#define FLAG_JOIN_START_RETRACT 8 |
Start filament retraction at move start
#define FLAG_JOIN_STEPPARAMS_COMPUTED 1 |
Are the step parameter computed
#define FLAG_JOIN_WAIT_EXTRUDER_DOWN 128 |
Wait for the extruder to finish it's down movement
#define FLAG_JOIN_WAIT_EXTRUDER_UP 64 |
Wait for the extruder to finish it's up movement
#define FLAG_NOMINAL 2 |
#define FLAG_SKIP_ACCELERATING 32 |
#define FLAG_SKIP_DEACCELERATING 64 |
#define FLAG_WARMUP 1 |
Marks the first step of a new move