eink bootloader finished

bin/install-bootloader.sh

@@ -1,5 +1,7 @@
 # You probably don't want to use this script, it programs a custom bootloader build onto a nrf52 board
 
+set -e 
+
 BOOTDIR=/home/kevinh/development/meshtastic/Adafruit_nRF52_Bootloader
 
 nrfjprog --eraseall -f nrf52
@@ -9,7 +11,7 @@ nrfjprog --eraseall -f nrf52
 
 echo Programming bootloader and soft device
 # the following ling incorrectly enables reset pin, because the running code rewrites it
-nrfjprog --program $BOOTDIR/_build/build-ttgo_eink/ttgo_eink_bootloader-0.3.2-122-gf6bfaac-dirty_s140_6.1.1.hex -f nrf52
+nrfjprog --program $BOOTDIR/_build/build-ttgo_eink/ttgo_eink_bootloader-0.3.2-123-g4f9022d-dirty_s140_6.1.1.hex -f nrf52
 
 # this generates an intel hex file that can be programmed into a NRF52 to tell the adafruit bootloader that the current app image is valid
 # Bootloader settings are at BOOTLOADER_SETTINGS (rw) : ORIGIN = 0xFF000, LENGTH = 0x1000

variants/eink/variant.h

@@ -51,11 +51,14 @@ feedback to give:
 
 * remove ipx connector for nfc, instead use two caps and loop traces on the back of the board as an antenna?
 
+* the i2c RTC seems to talk fine on the i2c bus
+
 * I've made the serial flash chip work, but if you do a new spin of the board I recommend:
 connect pin 3 and pin 7 of U4 to spare GPIOs on the processor (instead of their current connections), 
-This would allow using 4 bit wide interface mode to the serial flash.
-doubling the transfer speed! see example here:
+This would allow using 4 bit wide interface mode to the serial flash - doubling the transfer speed! see example here:
 https://infocenter.nordicsemi.com/topic/ug_nrf52840_dk/UG/nrf52840_DK/hw_external_memory.html?cp=4_0_4_7_4
+Once again - I'm glad you added that external flash chip. 
+
 */
 
 /*----------------------------------------------------------------------------