2022-01-19 00:35:42 +00:00
|
|
|
// the default ESP32 Pin of 15 is the Oled SCL, set to 36 and 37 and works fine.
|
|
|
|
|
// Tested on Neo6m module.
|
|
|
|
|
#undef GPS_RX_PIN
|
|
|
|
|
#undef GPS_TX_PIN
|
|
|
|
|
#define GPS_RX_PIN 36
|
2022-04-02 10:57:10 +00:00
|
|
|
#define GPS_TX_PIN 33
|
2022-01-19 00:35:42 +00:00
|
|
|
|
|
|
|
|
#ifndef USE_JTAG // gpio15 is TDO for JTAG, so no I2C on this board while doing jtag
|
|
|
|
|
#define I2C_SDA 4 // I2C pins for this board
|
|
|
|
|
#define I2C_SCL 15
|
|
|
|
|
#endif
|
|
|
|
|
|
|
|
|
|
#define RESET_OLED 16 // If defined, this pin will be used to reset the display controller
|
|
|
|
|
|
|
|
|
|
#define VEXT_ENABLE 21 // active low, powers the oled display and the lora antenna boost
|
|
|
|
|
#define LED_PIN 25 // If defined we will blink this LED
|
|
|
|
|
#define BUTTON_PIN 0 // If defined, this will be used for user button presses
|
|
|
|
|
|
|
|
|
|
#define USE_RF95
|
|
|
|
|
#define LORA_DIO0 26 // a No connect on the SX1262 module
|
|
|
|
|
#ifndef USE_JTAG
|
|
|
|
|
#define LORA_RESET 14
|
|
|
|
|
#endif
|
|
|
|
|
#define LORA_DIO1 35 // Not really used
|
|
|
|
|
#define LORA_DIO2 34 // Not really used
|
|
|
|
|
|
2022-01-24 18:01:23 +00:00
|
|
|
// ratio of voltage divider = 3.20 (R12=100k, R10=220k)
|
2022-01-23 16:04:55 +00:00
|
|
|
#define ADC_MULTIPLIER 3.2
|
2022-01-19 00:35:42 +00:00
|
|
|
#define BATTERY_PIN 13 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
|
|
|
|
|
|
