2020-02-01 17:46:25 +00:00
# High priority
2020-02-02 02:45:27 +00:00
* solder debug headers to board - debug sendTo hang bug
2020-02-01 22:23:02 +00:00
* make message send from android go to service, then to mesh radio
* make message receive from radio go through to android
* have MeshService keep a node DB by sniffing user messages
* have meshservice send location data on mesh (if device has a GPS)
2020-02-01 17:46:25 +00:00
# Medium priority
2020-02-02 02:45:27 +00:00
* use https://lastminuteengineers.com/esp32-sleep-modes-power-consumption/ association sleep pattern to save power - but see https://github.com/espressif/esp-idf/issues/2070
2020-02-01 19:56:32 +00:00
* correctly map nodeids to nodenums, currently we just do a proof of concept by always doing a broadcast
2020-02-01 17:46:25 +00:00
* add interrupt detach/sleep mode config to lora radio so we can enable deepsleep without panicing
2020-02-01 19:25:07 +00:00
* figure out if we can use PA_BOOST
* scrub default radio config settings for bandwidth/range/speed
* use a freertos thread to remain blocked reading from recvfromAckTimeout, so that we don't need to keep polling it from our main thread
* override peekAtMessage so we can see any messages that pass through our node (even if not broadcast)? would that be useful?
2020-02-02 00:05:12 +00:00
* sendToMesh can currently block for a long time, instead have it just queue a packet for a radio freertos thread
2020-02-02 03:09:17 +00:00
* see section 7.3 of https://cdn.sparkfun.com/assets/learn_tutorials/8/0/4/RFM95_96_97_98W.pdf and have hope radio wake only when a valid packet is received. Possibly even wake the ESP32 from deep sleep via GPIO.
2020-02-02 00:05:12 +00:00
* fix the logo
2020-02-01 19:25:07 +00:00
# Pre-beta priority
2020-02-02 02:45:27 +00:00
* do hibernation mode to get power draw down to 2.5uA https://lastminuteengineers.com/esp32-sleep-modes-power-consumption/
2020-02-01 19:25:07 +00:00
* make sure main cpu is not woken for packets with bad crc or not addressed to this node - do that in the radio hw
* enable fast init inside the gps chip
* dynamically select node nums
* triple check fcc compliance
* allow setting full radio params from android
2020-02-01 17:46:25 +00:00
2020-02-02 00:05:12 +00:00
# Low priority
* report esp32 device code bugs back to the mothership via android
2020-02-01 17:46:25 +00:00
# Done
* change the partition table to take advantage of the 4MB flash on the wroom: http://docs.platformio.org/en/latest/platforms/espressif32.html#partition-tables
2020-02-01 19:25:07 +00:00
* wrap in nice MeshRadio class
* add mesh send & rx
