# /usr/bin/env bash
#
# Helper script to start up the Wenet Docker image.
#
# This script is intended to be downloaded using wget or otherwise,
# and modified prior to use.
#

# Your station callsign, which will be shown on https://ssdv.habhub.org
# when receiving packets.
# Make sure there is no space between the = and your callsign.
MYCALL=CHANGEME

# Receive Frequency (Hz)
# The normal receive frequency used by Project Horus is 443.5 MHz
RXFREQ=443500000

# Receiver Gain. Set this to 0 to use automatic gain control, otherwise if running a
# preamplifier, you may want to experiment with lower gain settings to optimize
# your receiver setup.
# You can find what gain range is valid for your RTLSDR by running: rtl_test
# A very rough figure that may work if you are running a preamp with ~20 dB gain is
# 32.8 - your performance may vary!
GAIN=0

# Bias Tee Enable (1) or Disable (0)
# Enable this is you are intending on powering a preamplifer via coax from your RTLSDR
BIAS=0


# Stop and remove any existing wenet instances
echo "Stopping/Removing any existing Wenet instances..."
docker stop wenet || true && docker rm wenet || true

# Start the container!
echo "Starting new Wenet instance..."
docker run -d \
	--name wenet \
	-e MYCALL=$MYCALL \
	-e RXFREQ=$RXFREQ \
	-e GAIN=$GAIN \
	-e BIAS=$BIAS \
	-v ~/wenet/rx_images/:/opt/wenet/rx_images/ \
	--device /dev/bus/usb \
	-p 5003:5003 \
	ghcr.io/projecthorus/wenet:latest

echo "Navigate to http://localhost:5003/ in your web browser to see the Wenet interface!"