The Status page provides an overview of your Stratux device.

The current state of you device is shown at the top - Connected in green or Disconectedin red.

Depending on the hardware you have installed in your Stratux, status messages will be shown for the following:

• Messages is the number of messages received by the UAT (978 MHz) and 1090 MHz radios. "Current" is the 60-second rolling total for each receiver; "Peak" is the maximum 60-second total. The 1090 total includes all 1090 MHz Mode S messages received, including all-call and TCAS interrogations that do not carry ADS-B position information. If a UAT radio is receiving uplinks from one or more ground-based transceivers (GBT), this will be indicated under UAT Towers, with more details available on the Towers page.
• GPS indicates the connection status of any attached GPS receivers. Reported data includes the type of position solution, the number of satellites used in that solution, the number of satellites being received, and the number of satellites tracked in the GPS almanac data. Position and accuracy details can be viewed on the GPS/AHRS page.
• AHRS indicates whether the pressure sensor and gyro on an RY835AI or similar 10-axis module are connected and enabled. If connected, attitude and pressure altitude can be viewed on the GPS/AHRS page.

Devices must be manually enabled on the Settings page.

Additional statistics include the number of detected software-defined radios (SDRs), number of current DHCP network clients, uptime, temperature of the Raspberry Pi CPU, and the current clock settings on both the Raspberry Pi and the device / browser used to view this page.