0dd466a900
screen when screen orientation changes. Add DialPopup to allow dials to adjusted with a slider, which is easier on touchscreens. Add TableTapAndHold to support table context menus on touchscreens. |
||
|---|---|---|
| .. | ||
| CMakeLists.txt | ||
| kiwisdrgui.cpp | ||
| kiwisdrgui.h | ||
| kiwisdrgui.ui | ||
| kiwisdrinput.cpp | ||
| kiwisdrinput.h | ||
| kiwisdrplugin.cpp | ||
| kiwisdrplugin.h | ||
| kiwisdrsettings.cpp | ||
| kiwisdrsettings.h | ||
| kiwisdrwebapiadapter.cpp | ||
| kiwisdrwebapiadapter.h | ||
| kiwisdrworker.cpp | ||
| kiwisdrworker.h | ||
| readme.md | ||
readme.md
KiwiSDR input plugin
Introduction
This plugin is designed to enable connection to publicly available KiwiSDR receivers. A list of on-line receivers is available here
Interface
The top and bottom bars of the device window are described here
1: Start/Stop
This button is used to start the "device" i.e connect to the remote and start stream or stop the "device" i.e. stop stream and disconnect from the remote. The button shows the following faces:
- Blue triangle icon: device is ready and can be started
- Green square icon: device is running and can be stopped
3: Frequency
This is the center frequency of reception in kHz.
4: Stream sample rate
This is the 12 kS/s fixed sample rate of the I/Q stream provided by the Kiwi.
5: Remote address and port
This is the remote address and port of the remote KiwiSDR instance to which to connect. The address can be in the form of an URL or IPv4 address. This is the same address and port found in the servers list of SDR.hu for example. Note that the http:// prefix should be removed this should be only the address and port.
Press button (7) to validate your change.
6: Status indicator
This ball can take the following colors depending on the status:
- Gray: Idle
- Yellow: Connecting
- Green: Connected
- Red: Error
- Magenta: Disconnected
The connection can take several seconds (yellow status) please be patient.
In case of untimely disconnection (magenta status) you can stop and start again with button (1) to attempt re-connection.
7: Set address
When you change the address in (5) you have to push this button to validate the change.
8: Gain
This is the RF gain control sent to the remote
9: AGC
Use this button to switch on or off the AGC in the remote
10: DC block
Some remote receivers exhibit a peak at DC. Use this button to filter DC out.