micropython/examples/rp2/pio_uart_rx.py

105 wiersze
2.7 KiB
Python

# Example using PIO to create a UART RX interface.
#
# To make it work you'll need a wire connecting GPIO4 and GPIO3.
#
# Demonstrates:
# - PIO shifting in data on a pin
# - PIO jmp(pin) instruction
# - PIO irq handler
# - using the second core via _thread
import _thread
from machine import Pin, UART
from rp2 import PIO, StateMachine, asm_pio
UART_BAUD = 9600
HARD_UART_TX_PIN = Pin(4, Pin.OUT)
PIO_RX_PIN = Pin(3, Pin.IN, Pin.PULL_UP)
@asm_pio(
autopush=True,
push_thresh=8,
in_shiftdir=rp2.PIO.SHIFT_RIGHT,
)
def uart_rx_mini():
# fmt: off
# Wait for start bit
wait(0, pin, 0)
# Preload bit counter, delay until eye of first data bit
set(x, 7) [10]
# Loop 8 times
label("bitloop")
# Sample data
in_(pins, 1)
# Each iteration is 8 cycles
jmp(x_dec, "bitloop") [6]
# fmt: on
@asm_pio(
in_shiftdir=rp2.PIO.SHIFT_RIGHT,
)
def uart_rx():
# fmt: off
label("start")
# Stall until start bit is asserted
wait(0, pin, 0)
# Preload bit counter, then delay until halfway through
# the first data bit (12 cycles incl wait, set).
set(x, 7) [10]
label("bitloop")
# Shift data bit into ISR
in_(pins, 1)
# Loop 8 times, each loop iteration is 8 cycles
jmp(x_dec, "bitloop") [6]
# Check stop bit (should be high)
jmp(pin, "good_stop")
# Either a framing error or a break. Set a sticky flag
# and wait for line to return to idle state.
irq(block, 4)
wait(1, pin, 0)
# Don't push data if we didn't see good framing.
jmp("start")
# No delay before returning to start; a little slack is
# important in case the TX clock is slightly too fast.
label("good_stop")
push(block)
# fmt: on
# The handler for a UART break detected by the PIO.
def handler(sm):
print("break", time.ticks_ms(), end=" ")
# Function for core1 to execute to write to the given UART.
def core1_task(uart, text):
uart.write(text)
# Set up the hard UART we're going to use to print characters.
uart = UART(1, UART_BAUD, tx=HARD_UART_TX_PIN)
for pio_prog in ("uart_rx_mini", "uart_rx"):
# Set up the state machine we're going to use to receive the characters.
sm = StateMachine(
0,
globals()[pio_prog],
freq=8 * UART_BAUD,
in_base=PIO_RX_PIN, # For WAIT, IN
jmp_pin=PIO_RX_PIN, # For JMP
)
sm.irq(handler)
sm.active(1)
# Tell core 1 to print some text to UART 1
text = "Hello, world from PIO, using {}!".format(pio_prog)
_thread.start_new_thread(core1_task, (uart, text))
# Echo characters received from PIO to the console.
for i in range(len(text)):
print(chr(sm.get() >> 24), end="")
print()