Program your board using the esptool.py program, found [here](https://github.com/espressif/esptool). To flash or erase your FeatherS2, you have to first put it into download mode. To do this, follow these steps: - Press and hold the [BOOT] button - Press and release the [RESET] button - Release the [BOOT] button Now the board is in download mode and the native USB will have enumerated as a serial device. If you are putting MicroPython on your board for the first time then you should first erase the entire flash using: ### Linux ```bash esptool.py --chip esp32s2 --port /dev/ttyACM0 erase_flash ``` ### Mac ```bash esptool.py --chip esp32s2 --port /dev/cu.usbmodem01 erase_flash ``` ### Windows Change (X) to whatever COM port is being used by the board ```bash esptool --chip esp32s2 --port COM(X) erase_flash ``` Now download the version of the firmware you would like to install from the options below, then use the following command to program the firmware starting at address 0x1000, remembering to replace `feathers2-micropython-firmware-version.bin` with the name of the firmware you just downloaded: ### Linux ```bash esptool.py --chip esp32s2 --port /dev/ttyACM0 write_flash -z 0x1000 feathers2-micropython-firmware-version.bin ``` ### Mac ```bash esptool.py --chip esp32s2 --port /dev/cu.usbmodem01 write_flash -z 0x1000 feathers2-micropython-firmware-version.bin ``` ### Windows Change (X) to whatever COM port is being used by the board ```bash esptool --chip esp32s2 --port COM(X) write_flash -z 0x1000 feathers2-micropython-firmware-version.bin ```