Recent changes to builtin print meant that print was printing to the
mp_sys_stdout_obj, which was sending data raw to the USB CDC device.
The data should be cooked so that \n turns into \r\n.
Blanket wide to all .c and .h files. Some files originating from ST are
difficult to deal with (license wise) so it was left out of those.
Also merged modpyb.h, modos.h, modstm.h and modtime.h in stmhal/.
All board config macros now begin with MICROPY_HW_.
Renamed PYBv10 to PYBV10, since macros should be all uppercase.
Made SDCARD_DETECT configurable in mpconfigport.h, so that the SD
detect pin can be easily configured.
Can now choose at boot up whether the USB device is CDC+MSC or CDC+HID.
Choice is made by an option in boot.py, with default being CDC+MSC.
HID+MSC is not currently supported, but should be easy to implement.
Boot up now has ability to change the reset mode: hold down USR switch
while booting and LEDs will count from 1 to 7 to indicate the boot mode.
Release USR when correct mode is selected. Current modes are 1 (normal
boot), 2 (safe mode), 3 (reset FS mode).
New USB HAL is quite a bit improved over previous one. Now has better
callbacks and flow control.
REPL over USB CDC now works as before, except for soft-reset (since USB
driver uses malloc...).
Damien George