micropython/ports/stm32/boards/NETDUINO_PLUS_2/pins.csv

D0,PC7
D1,PC6
D2,PA3
D3,PA2
D4,PB12
D5,PB8
D6,PB9
D7,PA1
D8,PA0
D9,PA6
D10,PB10
D11,PB15
D12,PB14
D13,PB13
SDA,PB6
SCL,PB7
A0,PC0
A1,PC1
A2,PC2
A3,PC3
A4,PC4
A5,PC5
LED,PA10
SW,PB11
PWR_LED,PC13
PWR_SD,PB1
PWR_HDR,PB2
PWR_ETH,PC15
RST_ETH,PD2
UART1_TX,PA9
UART3_TX,PD8
UART3_RX,PD9
UART3_RTS,PD12
UART3_CTS,PD11
UART5_TX,PC12
USB_DM,PA11
USB_DP,PA12
Initial checkin with STM HAL This compiles and links, but hasn't been tested on a board yet and even if it was run, it doesn't currently do anything. 2014-03-12 06:55:41 +00:00			`D0,PC7`
			`D1,PC6`
			`D2,PA3`
			`D3,PA2`
			`D4,PB12`
			`D5,PB8`
			`D6,PB9`
			`D7,PA1`
			`D8,PA0`
			`D9,PA6`
			`D10,PB10`
			`D11,PB15`
			`D12,PB14`
			`D13,PB13`
stmhal: Some NETDUINO_PLUS_2 cleanup - Put the I2C bus on the corect pins - Add the appropriate board_init to power the shield 2016-02-13 05:25:00 +00:00			`SDA,PB6`
			`SCL,PB7`
Initial checkin with STM HAL This compiles and links, but hasn't been tested on a board yet and even if it was run, it doesn't currently do anything. 2014-03-12 06:55:41 +00:00			`A0,PC0`
			`A1,PC1`
			`A2,PC2`
			`A3,PC3`
			`A4,PC4`
			`A5,PC5`
			`LED,PA10`
			`SW,PB11`
			`PWR_LED,PC13`
			`PWR_SD,PB1`
			`PWR_HDR,PB2`
			`PWR_ETH,PC15`
			`RST_ETH,PD2`
stmhal: Refactor UART configuration to use pin objects. This follows the pattern of other peripherals (I2C, SPI) to specify the pins using pin objects instead of a pair of GPIO port and pin number. It makes it easier to customise the UART pins for a particular board. 2016-12-05 01:21:45 +00:00			`UART1_TX,PA9`
			`UART3_TX,PD8`
			`UART3_RX,PD9`
			`UART3_RTS,PD12`
			`UART3_CTS,PD11`
			`UART5_TX,PC12`
stm32/boards: Update pins.csv to include USB pins where needed. 2018-05-01 07:38:51 +00:00			`USB_DM,PA11`
			`USB_DP,PA12`