kopia lustrzana https://github.com/micropython/micropython
23 wiersze
774 B
Markdown
23 wiersze
774 B
Markdown
|
Program your board using the `esptool.py` program, found
|
||
|
|
[here](https://github.com/espressif/esptool).
|
||
|
|
|
||
|
|
To place the board in _bootloader mode_ - so `esptool`` can be used - press and
|
||
|
|
hold the reset button for two seconds. A green LED will flash behind the reset
|
||
|
|
button when the bootloader mode has been activated.
|
||
|
|
|
||
|
|
If you are putting MicroPython on your board for the first time then you should
|
||
|
|
first erase the entire flash using:
|
||
|
|
|
||
|
|
```bash
|
||
|
|
esptool.py --chip esp32s3 --port /dev/ttyACM0 erase_flash
|
||
|
|
```
|
||
|
|
|
||
|
|
From then on program the firmware starting at address 0:
|
||
|
|
|
||
|
|
```bash
|
||
|
|
esptool.py --chip esp32s3 --port /dev/ttyACM0 write_flash -z 0 board-20240105-v1.22.1.bin
|
||
|
|
```
|
||
|
|
|
||
|
|
After the firmware has been deployed, press the reset button to reset the device
|
||
|
|
and start the new firmware.
|