micropython/ports/esp32/boards/GENERIC_C3_USB/mpconfigboard.cmake

set(IDF_TARGET esp32c3)

set(SDKCONFIG_DEFAULTS
    boards/sdkconfig.base
    boards/sdkconfig.ble
    boards/GENERIC_C3_USB/sdkconfig.board
)
esp32/boards: Add GENERIC_C3_USB board with USB serial/JTAG support. Add a new board type for ESP32-C3 revision 3 and up that implement the USB serial/JTAG port on pin 18 and 19. This variant uses the USB serial for programming and console, leaving the UART free. - Pins 18 and 19 are correctly reserved for this variant. Also pins 14-17 are reserved for flash for any ESP32-C3 so they can't be reconfigured anymore to crash the system. - Added usb_serial_jtag.c and .h to implement this interface. - Interface was tested to work correctly together with webrepl. - Interface was tested to work correctly when sending and receiving large files with ampy. - Disconnecting terminal or USB will not hang the system when it's trying to print. 2021-08-26 18:19:46 +00:00			`set(IDF_TARGET esp32c3)`

			`set(SDKCONFIG_DEFAULTS`
			`boards/sdkconfig.base`
			`boards/sdkconfig.ble`
			`boards/GENERIC_C3_USB/sdkconfig.board`
			`)`