* Isolate esp32 adc logic gymnastics, try simplifying getBattVoltage
* Set sense resolution for pico platforms
* try silencing cppcheck when variant has no battery pin
* ADC channel for esp-idf calibration
* Missed an rp2040 device
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* Add debug options for RP2040
* Rename: "observed" should be plural: "observables"
* PhoneAPI: return failure on timeout
In `onNotify()`, when disconnected, PhoneAPI removed itself from the list of observers that was looped through in `notifyObservers()`. We should exit that loop in that case.
* Use UINT32_MAX to indicate no configured GPS
* Refactor GPS to not probe if pins not defined
* Minor cleanups related to rework
* Use Named Constructor to clean up code
* Actually disable the GPS thread
* Don't actually disable the GPS thread
* Move doGPSPowerSave to GPS class
* Make sure to set GPS awake on triple-click
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
* POC. Board definition JSON upcoming. Generic for now
* side-effect: RP2040 is building again.
* WIP Pico Targets
* current state of affairs
* ahem
* POC. Board definition JSON upcoming. Generic for now
* side-effect: RP2040 is building again.
* WIP Pico Targets
* current state of affairs
* ahem
* fmt
* update toolkit and fmt
* Add built in LED pin
* Use arduino pins
* init SPI bus on right pins.
* Use SPI1 and control chip select manually
* Use macro define for SPI selection. This needs to be defined in the ini file since portduino needs it inside the framework source
* Remove manual CS; works when not using setCS()
* Remove whoopsie debug line
* we are not ARDUINO_AVR_NANO_EVERY any more
* fix rp2040 compilation
* fix RadioLibHAL
* Use new arduino-pico core
* Use cortex-m0plus for BSEC2 library
* Forgot RAK11310 target for BSEC2 library
* That branch was merged
* RAK11310 is working too
---------
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
Co-authored-by: GUVWAF <thijs@havinga.eu>
Thomas Göttgens