Delete variant.h

variant.h

@@ -1,31 +0,0 @@
-// the default ESP32 Pin of 15 is the Oled SCL, set to 36 and 37 and works fine.
-// Tested on Neo6m module.
-#undef GPS_RX_PIN
-#undef GPS_TX_PIN
-#define GPS_RX_PIN 36
-#define GPS_TX_PIN 37
-
-#ifndef USE_JTAG  // gpio15 is TDO for JTAG, so no I2C on this board while doing jtag
-#define I2C_SDA 4 // I2C pins for this board
-#define I2C_SCL 15
-#endif
-
-#define RESET_OLED 16 // If defined, this pin will be used to reset the display controller
-
-#define VEXT_ENABLE 21 // active low, powers the oled display and the lora antenna boost
-#define LED_PIN 25     // If defined we will blink this LED
-#define BUTTON_PIN 0   // If defined, this will be used for user button presses
-
-#define USE_RF95
-#define LORA_DIO0 26 // a No connect on the SX1262 module
-#ifndef USE_JTAG
-#define LORA_RESET 14
-#endif
-#define LORA_DIO1 35 // Not really used
-#define LORA_DIO2 34 // Not really used
-
-// ratio of voltage divider = 3.20 (schematic R12=100k, R10=220k)
-// device to device variations, the actual ratio can be between 3.2 and 4
-#define ADC_MULTIPLIER 3.6 // best fit
-#define BATTERY_PIN 37 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
-#define EXT_NOTIFY_OUT 13 // Default pin to use for Ext Notify Plugin.