new Configuration section

src/configuration.h

@@ -323,6 +323,41 @@ along with this program.  If not, see <http://www.gnu.org/licenses/>.
 
 #endif
 
+#elif defined(ARDUINO_HELTEC_WIFI_LORA_32)
+
+// the default ESP32 Pin of 15 is the Oled SCL, set to 36 and 37 and works fine.
+// Tested on Neo6m module.
+#undef GPS_RX_PIN
+#undef GPS_TX_PIN
+#define GPS_RX_PIN 36
+#define GPS_TX_PIN 37
+
+#ifndef USE_JTAG  // gpio15 is TDO for JTAG, so no I2C on this board while doing jtag
+#define I2C_SDA 4 // I2C pins for this board
+#define I2C_SCL 15
+#endif
+
+#define RESET_OLED 16 // If defined, this pin will be used to reset the display controller
+
+#define LED_PIN 25     // If defined we will blink this LED
+#define BUTTON_PIN 0   // If defined, this will be used for user button presses
+
+#define USE_RF95
+#define LORA_DIO0 26 // a No connect on the SX1262 module
+#ifndef USE_JTAG
+#define LORA_RESET 14
+#endif
+#define LORA_DIO1 33 // Not really used
+#define LORA_DIO2 32 // Not really used
+
+// ratio of voltage divider = 3.20 (R1=100k, R2=220k)
+#define ADC_MULTIPLIER 3.2
+
+// This string must exactly match the case used in release file names or the android updater won't work
+#define HW_VENDOR HardwareModel_HELTEC_V1
+
+#define BATTERY_PIN 13 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
+
 #elif defined(TLORA_V1)
 // This string must exactly match the case used in release file names or the android updater won't work
 #define HW_VENDOR HardwareModel_TLORA_V1