kopia lustrzana https://github.com/gnea/grbl
30 wiersze
1.4 KiB
Plaintext
30 wiersze
1.4 KiB
Plaintext
Grbl - An embedded rs274/ngc (g-code) interpreter and motion-controller for the Arduino/AVR328 microcontroller
|
|
|
|
Goal: A no-compromise, high performance, low cost alternative to parallel-port based motion control for CNC milling
|
|
|
|
Status:
|
|
* Ready for production, but probably rough around the edges still
|
|
* Highly optimized C utilizing the hardware-timers of the AVR-chip for all critical timing
|
|
* Able to maintain more than 30kHz step rate, generating an ultra clean, jitter free step-signal
|
|
* G-code interpreter complete, tested with output from several CAM tools
|
|
* Standards-compliant g-code arcs/circles fully supported
|
|
* Buffered, non blocking, asynchronous step generation so the rest of the system is free to process
|
|
g-code while the steppers are steppin'
|
|
* Configuration parameters stored in EEPROM and set via simple commands
|
|
* Tested on very few (two) CNC rigs
|
|
|
|
Pending:
|
|
* Battle hardening in the field
|
|
* Documentation and web-site
|
|
* Optional support for a alphanumeric LCD readout, a joystick and a few buttons for program control
|
|
* Support "headless" fabrication by buffering all code to SD-card or similar
|
|
* Easing of feed rate
|
|
* Spindle control
|
|
|
|
Limitations by design:
|
|
* Limited GCode-support. Focus on the kind of GCode produced by CAM tools. Leave human GCoders frustrated.
|
|
* No support for tool offsets (typically handled by CAM-tool)
|
|
* No rotation axes, only x, y and z.
|
|
|
|
The project was initially inspired by the Arduino GCode Interpreter by Mike Ellery
|