diff --git a/grbl/config.h b/grbl/config.h
index 0fe4725..1863613 100644
--- a/grbl/config.h
+++ b/grbl/config.h
@@ -102,12 +102,12 @@
 // on separate pin, but homed in one cycle. Also, it should be noted that the function of hard limits
 // will not be affected by pin sharing.
 // NOTE: Defaults are set for a traditional 3-axis CNC machine. Z-axis first to clear, followed by X & Y.
-//#define HOMING_CYCLE_0 (1<<Z_AXIS)                // REQUIRED: First move Z to clear workspace.
-//#define HOMING_CYCLE_1 ((1<<X_AXIS)|(1<<Y_AXIS))  // OPTIONAL: Then move X,Y at the same time.
+#define HOMING_CYCLE_0 (1<<Z_AXIS)                // REQUIRED: First move Z to clear workspace.
+#define HOMING_CYCLE_1 ((1<<X_AXIS)|(1<<Y_AXIS))  // OPTIONAL: Then move X,Y at the same time.
 // #define HOMING_CYCLE_2                         // OPTIONAL: Uncomment and add axes mask to enable
 
 // NOTE: The following are two examples to setup homing for 2-axis machines.
-#define HOMING_CYCLE_0 ((1<<X_AXIS)|(1<<Y_AXIS))  // NOT COMPATIBLE WITH COREXY: Homes both X-Y in one cycle. 
+// #define HOMING_CYCLE_0 ((1<<X_AXIS)|(1<<Y_AXIS))  // NOT COMPATIBLE WITH COREXY: Homes both X-Y in one cycle. 
 
 // #define HOMING_CYCLE_0 (1<<X_AXIS)  // COREXY COMPATIBLE: First home X
 // #define HOMING_CYCLE_1 (1<<Y_AXIS)  // COREXY COMPATIBLE: Then home Y
@@ -126,7 +126,7 @@
 // After homing, Grbl will set by default the entire machine space into negative space, as is typical
 // for professional CNC machines, regardless of where the limit switches are located. Uncomment this
 // define to force Grbl to always set the machine origin at the homed location despite switch orientation.
-#define HOMING_FORCE_SET_ORIGIN // Uncomment to enable.
+// #define HOMING_FORCE_SET_ORIGIN // Uncomment to enable.
 
 // Number of blocks Grbl executes upon startup. These blocks are stored in EEPROM, where the size
 // and addresses are defined in settings.h. With the current settings, up to 2 startup blocks may