diff --git a/Compatible-boards.md b/Compatible-boards.md
index 1d9e265..fbbe72c 100644
--- a/Compatible-boards.md
+++ b/Compatible-boards.md
@@ -2,13 +2,13 @@
 All work was done on ESP32-WROOM with custom made **RA-01**/**SX1278** LoRa shield, Arduino Board is "ESP32 Dev Module".
 
 # Supported LoRa and other module types
-If using RadioLib then supported modules - modules, which are supported by [RadioLib](https://github.com/jgromes/RadioLib/wiki/Modules):
+If using **RadioLib** then supported modules - modules, which are supported by [RadioLib](https://github.com/jgromes/RadioLib/wiki/Modules):
 - **SX1278** is a default module, for other `SX127x` modules need to update `module_name.h`, replace `MODULE_NAME` with your module name 
 according to RadioLib naming
 - **SX1268** is used when `USE_SX126X` is enabled in `module_name.h`, for other `SX126x` modules need to set corresponding `MODULE_NAME` in `module_name.h`
 - other RadioLib module types - check [RadioLib documentation](https://github.com/jgromes/RadioLib/wiki/Modules), modify `module_name.h` and code accordingly, open Issue if help is needed, most likely it will not compile out of the box and some changes are needed.
 
-If using arduino-LoRa library then supported modules are **SX1276/77/78/79**.
+If using **arduino-LoRa** library then supported modules are **SX1276/77/78/79**.
 
 If your ESP32 board is compatible or has build in LoRa module then it should work without redefining pinouts, for custom shields there might be need to redefine pinouts to LoRa module if it differs (see further description in Software Setup section), currently pinouts are connected from LoRa to ESP32-WROOM as (SS/RST/DIO0 could be redefined in config.h):