Update README.md

README.md

@@ -4,7 +4,7 @@ Amateur radio ESP32 based LoRa APRSDroid KISS Bluetooth modem + LoRa APRS-IS RX/
 Can be used in two modes: 
 - **LoRa APRS KISS client over bluetooth** 
   - you need to use **APRSDroid** application (https://aprsdroid.org), connect to the modem using bluetooth, data will be re-transmitted through the LoRa radio, this is similar to APRSDroid micromodem - https://unsigned.io/micromodem/, received data will be sent back to the APRSDroid using bluetooth. By having two clients you can not only send your position, but also send and receive APRS messages
-  - it is also possible to use **other KISS APRS clients** over Bluetooth serial, just use `rfcomm` on Linux to setup serial over Bluetooth and put up AX25 interface with `kissattach`, then use any existing Linux APRS clients, such as `xastir`
+  - it is also possible to use **other KISS APRS clients** over Bluetooth serial, just use `rfcomm` on Linux to setup serial over Bluetooth and put up AX25 interface with `kissattach`, then use any existing Linux APRS clients, such as `xastir`, see section below for alternative Linux usage
 - **LoRa APRS iGate RX/TX server over WiFi + Digipeater**
   - **RF to APRS-IS gating**, it will connect to your WiFI and will forward received APRS positions from RF LoRa into the APRS-IS network, it also reports client signal level, by appending it into the APRS comment, so you can see your signal reports in different locations (could be enabled or disabled from config). This way, it is also possible to setup portable iGate by connecting to your mobile phone's hotspot and provide power from the phone USB port by using OTA cable
   - **APRS-IS to RF gating**, it is possible to enable it together with the filter in the config, so APRS-IS data will be forwarded to RF