From 52f8d0a01ccb1401aa69bdd65d529bf203e279ce Mon Sep 17 00:00:00 2001 From: sh123 Date: Mon, 15 Jun 2020 10:35:57 +0300 Subject: [PATCH] Update README.md --- README.md | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/README.md b/README.md index 03abb15..f5a9b45 100644 --- a/README.md +++ b/README.md @@ -4,7 +4,9 @@ Amateur radio ESP32 based LoRa APRSDroid KISS Bluetooth modem + LoRa APRS-IS RX/ ![alt text](images/pinouts.png) Can be used in two modes: -- **LoRa APRS KISS client over bluetooth**, you need to use APRSDroid application (https://aprsdroid.org), connect to the modem using bluetooth, data will be re-transmitted through the LoRa radio, this is similar to APRSDroid micromodem - https://unsigned.io/micromodem/, received data will be sent back to the APRSDroid using bluetooth. By having two clients you can not only send your position, but also send and receive APRS messages. Alternatively, it is possible to use other KISS APRS clients over serial, just use `rfcomm` on Linux to setup serial over Bluetooth and put up AX25 interface with `kissattach` +- **LoRa APRS KISS client over bluetooth**, + - you need to use **APRSDroid** application (https://aprsdroid.org), connect to the modem using bluetooth, data will be re-transmitted through the LoRa radio, this is similar to APRSDroid micromodem - https://unsigned.io/micromodem/, received data will be sent back to the APRSDroid using bluetooth. By having two clients you can not only send your position, but also send and receive APRS messages. Alternatively + - it is also possible to use **other KISS APRS clients** over serial, just use `rfcomm` on Linux to setup serial over Bluetooth and put up AX25 interface with `kissattach`, then use any existing Linux APRS clients, such as `Xastir` or even run `TCPIP` over AX25. - **LoRa APRS iGate RX/TX server + digipeater** - **RF to APRS-IS gating**, it will connect to WiFI and will forward received APRS positions from RF LoRAa into the APRS-IS network, it also reports client signal level, by appending it into the APRS comment, so you can see your signal reports in different locations (could be enabled or disabled from config) - **APRS-IS to RF gating**, it is possible to enable it together with the filter in the config, so APRS-IS data will be forwarded to RF