Documentation

config.h

@@ -19,9 +19,15 @@
 // lora pinouts, CAD and ISR usage
 #define CFG_LORA_PIN_SS       SS
 #define CFG_LORA_PIN_RST      LORA_RST
+// check board config!!
+// SX127x - DIO0
+// SX126X - DIO1
 #define CFG_LORA_PIN_DIO0     LORA_IRQ
 #ifdef USE_RADIOLIB
-#define CFG_LORA_PIN_DIO1     RADIOLIB_NC // set to your DIO1 pin number if connected
+// check board config!!
+// SX127X - DIO1 (if connected)
+// SX126X - BUSY
+#define CFG_LORA_PIN_DIO1     RADIOLIB_NC
 #define CFG_LORA_USE_ISR      true        // always ON for RadioLib
 #else
 #define CFG_LORA_PIN_DIO1     LORA_IRQ    // not used in arduino-LoRa

esp32_loraprs.ino

@@ -33,8 +33,9 @@ void initializeConfig(LoraPrs::Config &cfg) {
   // lora pinouts
   cfg.LoraPinSs = CFG_LORA_PIN_SS;
   cfg.LoraPinRst = CFG_LORA_PIN_RST;
-  cfg.LoraPinDio0 = CFG_LORA_PIN_DIO0;
+  // For RadioLib DIO0 and DIO1 will depend on Module signature, check RadioLib documentation
-  cfg.LoraPinDio1 = CFG_LORA_PIN_DIO1; // valid for radiolib only
+  cfg.LoraPinDio0 = CFG_LORA_PIN_DIO0; // depends on module type, might be DIO1 for SX126x!!
+  cfg.LoraPinDio1 = CFG_LORA_PIN_DIO1; // valid for radiolib only, depends on module type, might be BUSY for SX126x!!
   cfg.LoraUseIsr = CFG_LORA_USE_ISR;  // set to true for incoming packet ISR usage (stream mode, e.g. speech)
   cfg.LoraUseCad = CFG_LORA_USE_CAD;  // carrier detect