mirror
/
esp32_loraprs
kopia lustrzana https://github.com/sh123/esp32_loraprs
1
0
Forkuj 0
Kod Zgłoszenia Projekty Wydania Wiki Aktywność

Update README.md

pull/15/head
sh123 2020-06-15 10:36:33 +03:00 zatwierdzone przez GitHub
rodzic 52f8d0a01c
commit 03a4769582
Nie znaleziono w bazie danych klucza dla tego podpisu
ID klucza GPG: 4AEE18F83AFDEB23
1 zmienionych plików z 2 dodań i 2 usunięć
Pokaż statystyki Ściągnij plik aktualizacji Ściągnij plik porównania Expand all files Collapse all files

4
README.md
Wyświetl plik

@ -5,8 +5,8 @@ Amateur radio ESP32 based LoRa APRSDroid KISS Bluetooth modem + LoRa APRS-IS RX/
Can be used in two modes:
- **LoRa APRS KISS client over bluetooth**,
- you need to use **APRSDroid** application (https://aprsdroid.org), connect to the modem using bluetooth, data will be re-transmitted through the LoRa radio, this is similar to APRSDroid micromodem - https://unsigned.io/micromodem/, received data will be sent back to the APRSDroid using bluetooth. By having two clients you can not only send your position, but also send and receive APRS messages. Alternatively
- it is also possible to use **other KISS APRS clients** over serial, just use `rfcomm` on Linux to setup serial over Bluetooth and put up AX25 interface with `kissattach`, then use any existing Linux APRS clients, such as `Xastir` or even run `TCPIP` over AX25.
- you need to use **APRSDroid** application (https://aprsdroid.org), connect to the modem using bluetooth, data will be re-transmitted through the LoRa radio, this is similar to APRSDroid micromodem - https://unsigned.io/micromodem/, received data will be sent back to the APRSDroid using bluetooth. By having two clients you can not only send your position, but also send and receive APRS messages
- it is also possible to use **other KISS APRS clients** over serial, just use `rfcomm` on Linux to setup serial over Bluetooth and put up AX25 interface with `kissattach`, then use any existing Linux APRS clients, such as `Xastir` or even run `TCPIP` over AX25
- **LoRa APRS iGate RX/TX server + digipeater**
- **RF to APRS-IS gating**, it will connect to WiFI and will forward received APRS positions from RF LoRAa into the APRS-IS network, it also reports client signal level, by appending it into the APRS comment, so you can see your signal reports in different locations (could be enabled or disabled from config)
- **APRS-IS to RF gating**, it is possible to enable it together with the filter in the config, so APRS-IS data will be forwarded to RF