#ifndef __SSD1306_H__
#define __SSD1306_H__

// http://robotcantalk.blogspot.com/2015/03/interfacing-arduino-with-ssd1306-driven.html

// SLA (0x3C) + WRITE_MODE (0x00) =  0x78
#define OLED_I2C_ADDRESS   0x3C

// Control byte
#define OLED_CONTROL_BYTE_CMD_SINGLE    0x80
#define OLED_CONTROL_BYTE_CMD_STREAM    0x00
#define OLED_CONTROL_BYTE_DATA_STREAM   0x40

// Fundamental commands (pg.28)
#define OLED_CMD_SET_CONTRAST           0x81    // follow with 0x7F
#define OLED_CMD_DISPLAY_RAM            0xA4
#define OLED_CMD_DISPLAY_ALLON          0xA5
#define OLED_CMD_DISPLAY_NORMAL         0xA6
#define OLED_CMD_DISPLAY_INVERTED       0xA7
#define OLED_CMD_DISPLAY_OFF            0xAE
#define OLED_CMD_DISPLAY_ON             0xAF

// Addressing Command Table (pg.30)
#define OLED_CMD_SET_MEMORY_ADDR_MODE   0x20    // follow with 0x00 = HORZ mode = Behave like a KS108 graphic LCD
#define OLED_CMD_SET_COLUMN_RANGE       0x21    // can be used only in HORZ/VERT mode - follow with 0x00 and 0x7F = COL127
#define OLED_CMD_SET_PAGE_RANGE         0x22    // can be used only in HORZ/VERT mode - follow with 0x00 and 0x07 = PAGE7

// Hardware Config (pg.31)
#define OLED_CMD_SET_DISPLAY_START_LINE 0x40
#define OLED_CMD_SET_SEGMENT_REMAP      0xA1
#define OLED_CMD_SET_MUX_RATIO          0xA8    // follow with 0x3F = 64 MUX
#define OLED_CMD_SET_COM_SCAN_MODE      0xC8
#define OLED_CMD_SET_DISPLAY_OFFSET     0xD3    // follow with 0x00
#define OLED_CMD_SET_COM_PIN_MAP        0xDA    // follow with 0x12
#define OLED_CMD_NOP                    0xE3    // NOP

// Timing and Driving Scheme (pg.32)
#define OLED_CMD_SET_DISPLAY_CLK_DIV    0xD5    // follow with 0x80
#define OLED_CMD_SET_PRECHARGE          0xD9    // follow with 0xF1
#define OLED_CMD_SET_VCOMH_DESELCT      0xDB    // follow with 0x30

// Charge Pump (pg.62)
#define OLED_CMD_SET_CHARGE_PUMP        0x8D    // follow with 0x14

#endif // __SSD1306_H__