Historia

Adam Múdry 4c239a9db6 fix: i2c_eeprom_init use after free when error		2024-01-10 14:53:34 +01:00
..
components/i2c_eeprom	fix: i2c_eeprom_init use after free when error	2024-01-10 14:53:34 +01:00
main	docs(i2c): Modify some variables in I2C driver for good docs	2023-11-07 18:42:08 +08:00
CMakeLists.txt	feat(i2c_eeprom): Add new example for I2C eeprom with new API	2023-08-10 11:55:54 +08:00
README.md	feat(ci): Enable p4 example, test_apps and unit tests CI build	2023-08-24 12:51:19 +08:00

README.md

Supported Targets	ESP32	ESP32-C2	ESP32-C3	ESP32-C6	ESP32-H2	ESP32-P4	ESP32-S2	ESP32-S3

I2C EEPROM example

This code demonstrates how to use the I2C master mode to read/write I2C EEPROM.

Overview

This example demonstrates basic usage of I2C driver by reading and writing from a I2C connected eeprom:

If you have a new I2C application to go (for example, read the temperature data from external sensor with I2C interface), try this as a basic template, then add your own code.

How to use example

Hardware Required

To run this example, you should have one ESP32, ESP32-S, ESP32-C or ESP32-H based development board as well as EEPROM(s). I2C bus allow use several EEPROMs, and some of the EEPROMs' address are configurable. Some are not, for which you can use 74LS138 to set different EEPROM different slave address(It is also can be used on other types of I2C slaves).

For some I2C EEPROM slaves, they have A0, A1, A2 pins for address configuration. For some I2C slaves, They don't have address configuration pins but have enable pins. For these kind of slave, you can use GPIO pins and external decoder to select which slave you are using.

Pin Assignment:

Note: The following pin assignments are used by default, you can change these in the menuconfig .

	SDA	SCL
ESP I2C Master	I2C_MASTER_SDA	I2C_MASTER_SCL
EEPROM1	SDA	SCL
EEPROMn	SDA	SCL

For the actual default value of I2C_MASTER_SDA and I2C_MASTER_SCL see Example Configuration in menuconfig.

Note: There's no need to add an external pull-up resistors for SDA/SCL pin, because the driver will enable the internal pull-up resistors.

Build and Flash

Enter idf.py -p PORT flash monitor to build, flash and monitor the project.

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example Output

00 01 02 03 04 05 06 07 08 09 0a 0b 0c 0d 0e 0f 
10 11 12 13 14 15 16 17 18

Troubleshooting

(For any technical queries, please open an issue on GitHub. We will get back to you as soon as possible.)