esp-idf/examples/peripherals/mcpwm/mcpwm_servo_control
Roland Dobai 766aa57084 Build & config: Remove leftover files from the unsupported "make" build system 2021-11-11 15:32:36 +01:00
..
main Build & config: Remove leftover files from the unsupported "make" build system 2021-11-11 15:32:36 +01:00
CMakeLists.txt build_app: make multi target support readable 2020-04-09 16:40:57 +08:00
README.md docs: update readme link to not use parentheses 2021-07-30 09:19:04 +08:00

README.md

Supported Targets ESP32 ESP32-S3

MCPWM RC Servo Control Example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This example illustrates how to drive a typical RC Servo by sending a PWM signal using the MCPWM driver. The PWM pulse has a frequency of 50Hz (period of 20ms), and the active-high time (which controls the rotation) ranges from 1ms to 2ms with 1.5ms always being center of range.

How to Use Example

Hardware Required

  • A development board with any Espressif SoC which features MCPWM peripheral (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
  • A USB cable for Power supply and programming
  • A RC servo motor, e.g. SG90

Connection :

+-------+                                     +-----------------+
|       |                                     |                 |
|       +-+ GPIO18++  PWM(Orange)  +----------+                 |
|  ESP  |---5V------+ Vcc(Red) +--------------|   Servo Motor   |
|       +---------+   GND(Brown)   +----------+                 |
|       |                                     |                 |
+-------+                                     +-----------------+

Build and Flash

Run idf.py -p PORT flash monitor to build, flash and monitor the project.

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example Output

Run the example, you will see the following output log:

...
I (0) cpu_start: Starting scheduler on APP CPU.
I (349) example: Angle of rotation: -90
I (449) example: Angle of rotation: -89
I (549) example: Angle of rotation: -88
I (649) example: Angle of rotation: -87
I (749) example: Angle of rotation: -86
...

The servo will rotate from -90 degree to 90 degree, and then turn back again.

Troubleshooting

Note that, some kind of servo might need a higher current supply than the development board usually can provide. It's recommended to power the servo separately.

For any technical queries, please open an [issue] (https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.