…
|
||
---|---|---|
.. | ||
main | ||
CMakeLists.txt | ||
README.md | ||
sdkconfig.defaults |
README.md
Supported Targets | ESP32 | ESP32-C3 | ESP32-S2 | ESP32-S3 |
---|
Example: C++ I2C sensor read for MPU9250
(See the README.md file in the upper level 'examples' directory for more information about examples.)
This example demonstrates usage of C++ exceptions in ESP-IDF. It is the C++ equivalent to the I2C Simple Example which is written in C.
In this example, the sdkconfig.defaults
file sets the CONFIG_COMPILER_CXX_EXCEPTIONS
option. This enables both compile time support (-fexceptions
compiler flag) and run-time support for C++ exception handling. This is necessary for the C++ I2C API.
How to Use This Example
Hardware Required
To run this example, you should have one ESP32, ESP32-S series or ESP32-C series based development board as well as an MPU9250. MPU9250 is an inertial measurement unit, which contains an accelerometer, gyroscope as well as a magnetometer, for more information about it, you can read the datasheet of the MPU9250 sensor.
Pin Assignment:
Note: The following pin assignments are used by default, you can change these in the menuconfig
.
SDA | SCL | |
---|---|---|
ESP I2C Master | I2C_MASTER_SDA | I2C_MASTER_SCL |
MPU9250 Sensor | SDA | SCL |
For the actual default value of I2C_MASTER_SDA
and I2C_MASTER_SCL
, see Example Configuration
in menuconfig
.
Note: There's no need to add external pull-up resistors for SDA/SCL pins, because the driver will enable the internal pull-up resistors.
Configure the project
idf.py menuconfig
Build and Flash
idf.py -p <PORT> flash monitor
Replace with the name of the serial port. To exit the serial monitor, type Ctrl-]
.
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
Example Output
If the sensor is read correctly:
I (328) i2c-simple-example: I2C initialized successfully
I (338) i2c-simple-example: WHO_AM_I = 71
I (338) i2c-simple-example: I2C de-initialized successfully
If something went wrong:
I2C Exception with error: ESP_FAIL (-1)
Couldn't read sensor!