kopia lustrzana https://github.com/espressif/esp-idf
![]() |
||
---|---|---|
.. | ||
main | ||
CMakeLists.txt | ||
README.md | ||
pytest_http2_request.py | ||
sdkconfig.ci | ||
sdkconfig.defaults |
README.md
Supported Targets | ESP32 | ESP32-C3 | ESP32-S2 | ESP32-S3 |
---|
HTTP/2 Request Example
Establish an HTTP/2 connection with https://http2.github.io
- Performs a GET on /index.html
How to use example
Before project configuration and build, be sure to set the correct chip target using idf.py set-target <chip_name>
.
Hardware Required
- A development board with ESP32/ESP32-S2/ESP32-C3 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
- A USB cable for power supply and programming
Configure the project
idf.py menuconfig
Open the project configuration menu (idf.py menuconfig
) to configure Wi-Fi or Ethernet. See "Establishing Wi-Fi or Ethernet Connection" section in examples/protocols/README.md for more details.
Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
idf.py -p PORT flash monitor
(Replace PORT with the name of the serial port to use.)
(To exit the serial monitor, type Ctrl-]
.)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
Example Output
I (5609) example_connect: - IPv4 address: 192.168.0.103
I (5609) example_connect: - IPv6 address: fe80:0000:0000:0000:ae67:b2ff:fe45:0194, type: ESP_IP6_ADDR_IS_LINK_LOCAL
Connecting to server
Connection done
[get-response] <!DOCTYPE HTML>
<html lang="en">
.
.
.
Body of index.html
.
.
.
.
</html>
[get-response] Frame fully received
[get-response] Stream Closed