mirror
/
esp-idf
kopia lustrzana https://github.com/espressif/esp-idf
1
0
Forkuj 0
Kod Zgłoszenia Projekty Wydania Wiki Aktywność
esp-idf/examples/ethernet/eth2ap/main/ethernet_example_main.c

285 wiersze
10 KiB
C
Czysty Wina Historia

/* eth2ap (Ethernet to Wi-Fi AP packet forwarding) Example
This example code is in the Public Domain (or CC0 licensed, at your option.)
Unless required by applicable law or agreed to in writing, this
software is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR
CONDITIONS OF ANY KIND, either express or implied.
*/
#include <string.h>
#include <stdlib.h>
#include "sdkconfig.h"
#include "freertos/FreeRTOS.h"
#include "freertos/task.h"
#include "freertos/queue.h"
#include "esp_event.h"
#include "esp_log.h"
#include "esp_eth.h"
#include "esp_wifi.h"
#include "nvs_flash.h"
#include "esp_private/wifi.h"
#include "driver/gpio.h"
#if CONFIG_ETH_USE_SPI_ETHERNET
#include "driver/spi_master.h"
#endif
static const char *TAG = "eth_example";
static esp_eth_handle_t s_eth_handle = NULL;
static xQueueHandle flow_control_queue = NULL;
static bool s_sta_is_connected = false;
static bool s_ethernet_is_connected = false;
static uint8_t s_eth_mac[6];
#define FLOW_CONTROL_QUEUE_TIMEOUT_MS (100)
#define FLOW_CONTROL_QUEUE_LENGTH (40)
#define FLOW_CONTROL_WIFI_SEND_TIMEOUT_MS (100)
typedef struct {
void *packet;
uint16_t length;
} flow_control_msg_t;
// Forward packets from Wi-Fi to Ethernet
static esp_err_t pkt_wifi2eth(void *buffer, uint16_t len, void *eb)
{
if (s_ethernet_is_connected) {
if (esp_eth_transmit(s_eth_handle, buffer, len) != ESP_OK) {
ESP_LOGE(TAG, "Ethernet send packet failed");
}
}
esp_wifi_internal_free_rx_buffer(eb);
return ESP_OK;
}
// Forward packets from Ethernet to Wi-Fi
// Note that, Ethernet works faster than Wi-Fi on ESP32,
// so we need to add an extra queue to balance their speed difference.
static esp_err_t pkt_eth2wifi(esp_eth_handle_t eth_handle, uint8_t *buffer, uint32_t len, void *priv)
{
esp_err_t ret = ESP_OK;
flow_control_msg_t msg = {
.packet = buffer,
.length = len
};
if (xQueueSend(flow_control_queue, &msg, pdMS_TO_TICKS(FLOW_CONTROL_QUEUE_TIMEOUT_MS)) != pdTRUE) {
ESP_LOGE(TAG, "send flow control message failed or timeout");
free(buffer);
ret = ESP_FAIL;
}
return ret;
}
// This task will fetch the packet from the queue, and then send out through Wi-Fi.
// Wi-Fi handles packets slower than Ethernet, we might add some delay between each transmitting.
static void eth2wifi_flow_control_task(void *args)
{
flow_control_msg_t msg;
int res = 0;
uint32_t timeout = 0;
while (1) {
if (xQueueReceive(flow_control_queue, &msg, pdMS_TO_TICKS(FLOW_CONTROL_QUEUE_TIMEOUT_MS)) == pdTRUE) {
timeout = 0;
if (s_sta_is_connected && msg.length) {
do {
vTaskDelay(pdMS_TO_TICKS(timeout));
timeout += 2;
res = esp_wifi_internal_tx(WIFI_IF_AP, msg.packet, msg.length);
} while (res && timeout < FLOW_CONTROL_WIFI_SEND_TIMEOUT_MS);
if (res != ESP_OK) {
ESP_LOGE(TAG, "WiFi send packet failed: %d", res);
}
}
free(msg.packet);
}
}
vTaskDelete(NULL);
}
// Event handler for Ethernet
static void eth_event_handler(void *arg, esp_event_base_t event_base,
int32_t event_id, void *event_data)
{
switch (event_id) {
case ETHERNET_EVENT_CONNECTED:
ESP_LOGI(TAG, "Ethernet Link Up");
s_ethernet_is_connected = true;
esp_eth_ioctl(s_eth_handle, ETH_CMD_G_MAC_ADDR, s_eth_mac);
esp_wifi_set_mac(WIFI_IF_AP, s_eth_mac);
ESP_ERROR_CHECK(esp_wifi_start());
break;
case ETHERNET_EVENT_DISCONNECTED:
ESP_LOGI(TAG, "Ethernet Link Down");
s_ethernet_is_connected = false;
ESP_ERROR_CHECK(esp_wifi_stop());
break;
case ETHERNET_EVENT_START:
ESP_LOGI(TAG, "Ethernet Started");
break;
case ETHERNET_EVENT_STOP:
ESP_LOGI(TAG, "Ethernet Stopped");
break;
default:
break;
}
}
// Event handler for Wi-Fi
static void wifi_event_handler(void *arg, esp_event_base_t event_base,
int32_t event_id, void *event_data)
{
static uint8_t s_con_cnt = 0;
switch (event_id) {
case WIFI_EVENT_AP_STACONNECTED:
ESP_LOGI(TAG, "Wi-Fi AP got a station connected");
if (!s_con_cnt) {
s_sta_is_connected = true;
esp_wifi_internal_reg_rxcb(WIFI_IF_AP, pkt_wifi2eth);
}
s_con_cnt++;
break;
case WIFI_EVENT_AP_STADISCONNECTED:
ESP_LOGI(TAG, "Wi-Fi AP got a station disconnected");
s_con_cnt--;
if (!s_con_cnt) {
s_sta_is_connected = false;
esp_wifi_internal_reg_rxcb(WIFI_IF_AP, NULL);
}
break;
default:
break;
}
}
static void initialize_ethernet(void)
{
ESP_ERROR_CHECK(esp_event_handler_register(ETH_EVENT, ESP_EVENT_ANY_ID, eth_event_handler, NULL));
eth_mac_config_t mac_config = ETH_MAC_DEFAULT_CONFIG();
eth_phy_config_t phy_config = ETH_PHY_DEFAULT_CONFIG();
phy_config.phy_addr = CONFIG_EXAMPLE_ETH_PHY_ADDR;
phy_config.reset_gpio_num = CONFIG_EXAMPLE_ETH_PHY_RST_GPIO;
#if CONFIG_EXAMPLE_USE_INTERNAL_ETHERNET
mac_config.smi_mdc_gpio_num = CONFIG_EXAMPLE_ETH_MDC_GPIO;
mac_config.smi_mdio_gpio_num = CONFIG_EXAMPLE_ETH_MDIO_GPIO;
esp_eth_mac_t *mac = esp_eth_mac_new_esp32(&mac_config);
#if CONFIG_EXAMPLE_ETH_PHY_IP101
esp_eth_phy_t *phy = esp_eth_phy_new_ip101(&phy_config);
#elif CONFIG_EXAMPLE_ETH_PHY_RTL8201
esp_eth_phy_t *phy = esp_eth_phy_new_rtl8201(&phy_config);
#elif CONFIG_EXAMPLE_ETH_PHY_LAN8720
esp_eth_phy_t *phy = esp_eth_phy_new_lan8720(&phy_config);
#elif CONFIG_EXAMPLE_ETH_PHY_DP83848
esp_eth_phy_t *phy = esp_eth_phy_new_dp83848(&phy_config);
#elif CONFIG_EXAMPLE_ETH_PHY_KSZ8041
esp_eth_phy_t *phy = esp_eth_phy_new_ksz8041(&phy_config);
#endif
#elif CONFIG_ETH_USE_SPI_ETHERNET
gpio_install_isr_service(0);
spi_device_handle_t spi_handle = NULL;
spi_bus_config_t buscfg = {
.miso_io_num = CONFIG_EXAMPLE_ETH_SPI_MISO_GPIO,
.mosi_io_num = CONFIG_EXAMPLE_ETH_SPI_MOSI_GPIO,
.sclk_io_num = CONFIG_EXAMPLE_ETH_SPI_SCLK_GPIO,
.quadwp_io_num = -1,
.quadhd_io_num = -1,
};
ESP_ERROR_CHECK(spi_bus_initialize(CONFIG_EXAMPLE_ETH_SPI_HOST, &buscfg, 1));
#if CONFIG_EXAMPLE_USE_DM9051
spi_device_interface_config_t devcfg = {
.command_bits = 1,
.address_bits = 7,
.mode = 0,
.clock_speed_hz = CONFIG_EXAMPLE_ETH_SPI_CLOCK_MHZ * 1000 * 1000,
.spics_io_num = CONFIG_EXAMPLE_ETH_SPI_CS_GPIO,
.queue_size = 20
};
ESP_ERROR_CHECK(spi_bus_add_device(CONFIG_EXAMPLE_ETH_SPI_HOST, &devcfg, &spi_handle));
/* dm9051 ethernet driver is based on spi driver */
eth_dm9051_config_t dm9051_config = ETH_DM9051_DEFAULT_CONFIG(spi_handle);
dm9051_config.int_gpio_num = CONFIG_EXAMPLE_ETH_SPI_INT_GPIO;
esp_eth_mac_t *mac = esp_eth_mac_new_dm9051(&dm9051_config, &mac_config);
esp_eth_phy_t *phy = esp_eth_phy_new_dm9051(&phy_config);
#elif CONFIG_EXAMPLE_USE_W5500
spi_device_interface_config_t devcfg = {
.command_bits = 16, // Actually it's the address phase in W5500 SPI frame
.address_bits = 8, // Actually it's the control phase in W5500 SPI frame
.mode = 0,
.clock_speed_hz = CONFIG_EXAMPLE_ETH_SPI_CLOCK_MHZ * 1000 * 1000,
.spics_io_num = CONFIG_EXAMPLE_ETH_SPI_CS_GPIO,
.queue_size = 20
};
ESP_ERROR_CHECK(spi_bus_add_device(CONFIG_EXAMPLE_ETH_SPI_HOST, &devcfg, &spi_handle));
/* w5500 ethernet driver is based on spi driver */
eth_w5500_config_t w5500_config = ETH_W5500_DEFAULT_CONFIG(spi_handle);
w5500_config.int_gpio_num = CONFIG_EXAMPLE_ETH_SPI_INT_GPIO;
esp_eth_mac_t *mac = esp_eth_mac_new_w5500(&w5500_config, &mac_config);
esp_eth_phy_t *phy = esp_eth_phy_new_w5500(&phy_config);
#endif
#endif // CONFIG_ETH_USE_SPI_ETHERNET
esp_eth_config_t config = ETH_DEFAULT_CONFIG(mac, phy);
config.stack_input = pkt_eth2wifi;
ESP_ERROR_CHECK(esp_eth_driver_install(&config, &s_eth_handle));
#if !CONFIG_EXAMPLE_USE_INTERNAL_ETHERNET
/* The SPI Ethernet module might doesn't have a burned factory MAC address, we cat to set it manually.
02:00:00 is a Locally Administered OUI range so should not be used except when testing on a LAN under your control.
*/
ESP_ERROR_CHECK(esp_eth_ioctl(s_eth_handle, ETH_CMD_S_MAC_ADDR, (uint8_t[]) {
0x02, 0x00, 0x00, 0x12, 0x34, 0x56
}));
#endif
esp_eth_ioctl(s_eth_handle, ETH_CMD_S_PROMISCUOUS, (void *)true);
esp_eth_start(s_eth_handle);
}
static void initialize_wifi(void)
{
ESP_ERROR_CHECK(esp_event_handler_register(WIFI_EVENT, ESP_EVENT_ANY_ID, wifi_event_handler, NULL));
wifi_init_config_t cfg = WIFI_INIT_CONFIG_DEFAULT();
ESP_ERROR_CHECK(esp_wifi_init(&cfg));
ESP_ERROR_CHECK(esp_wifi_set_storage(WIFI_STORAGE_RAM));
wifi_config_t wifi_config = {
.ap = {
.ssid = CONFIG_EXAMPLE_WIFI_SSID,
.ssid_len = strlen(CONFIG_EXAMPLE_WIFI_SSID),
.password = CONFIG_EXAMPLE_WIFI_PASSWORD,
.max_connection = CONFIG_EXAMPLE_MAX_STA_CONN,
.authmode = WIFI_AUTH_WPA_WPA2_PSK,
.channel = CONFIG_EXAMPLE_WIFI_CHANNEL // default: channel 1
},
};
if (strlen(CONFIG_EXAMPLE_WIFI_PASSWORD) == 0) {
wifi_config.ap.authmode = WIFI_AUTH_OPEN;
}
ESP_ERROR_CHECK(esp_wifi_set_mode(WIFI_MODE_AP));
ESP_ERROR_CHECK(esp_wifi_set_config(WIFI_IF_AP, &wifi_config));
}
static esp_err_t initialize_flow_control(void)
{
flow_control_queue = xQueueCreate(FLOW_CONTROL_QUEUE_LENGTH, sizeof(flow_control_msg_t));
if (!flow_control_queue) {
ESP_LOGE(TAG, "create flow control queue failed");
return ESP_FAIL;
}
BaseType_t ret = xTaskCreate(eth2wifi_flow_control_task, "flow_ctl", 2048, NULL, (tskIDLE_PRIORITY + 2), NULL);
if (ret != pdTRUE) {
ESP_LOGE(TAG, "create flow control task failed");
return ESP_FAIL;
}
return ESP_OK;
}
void app_main(void)
{
esp_err_t ret = nvs_flash_init();
if (ret == ESP_ERR_NVS_NO_FREE_PAGES || ret == ESP_ERR_NVS_NEW_VERSION_FOUND) {
ESP_ERROR_CHECK(nvs_flash_erase());
ret = nvs_flash_init();
}
ESP_ERROR_CHECK(ret);
ESP_ERROR_CHECK(esp_event_loop_create_default());
ESP_ERROR_CHECK(initialize_flow_control());
initialize_ethernet();
initialize_wifi();
}
Reference in New Issue View Git Blame Kopiuj bezpośredni odnośnik