…
|
||
---|---|---|
.. | ||
main | ||
CMakeLists.txt | ||
README.md | ||
sdkconfig.defaults |
README.md
Supported Targets | ESP32-S2 |
---|
TinyUSB Sample Descriptor
(See the README.md file in the upper level 'examples' directory for more information about examples.)
This example is demonstrating how to set up ESP32-S2 chip to work as a Generic USB Device with a user-defined descriptor. You can specify a manufacturer, device's name, ID and other USB-devices parameters responsible for identification by host.
As a USB stack, a TinyUSB component is used.
How to use example
Hardware Required
- Any board with the ESP32-S2 chip
Configure the project
There are two ways to set up a descriptor - using Menuconfig tool and in-code
In-code setting up
For the manual descriptor's configuration use the default example's settings and modify tusb_sample_descriptor.c
according to your needs
Menuconfig
If you want to set up the desctiptor using Menuconfig UI:
-
Execute in the terminal from the example's directory:
idf.py menuconfig
-
Turn off
Set up a USB descriptor manually in code
parameter atExample Configuration
-
Folow to
Component config -> TinyUSB -> Descriptor configuration
for all available configurations.
Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
idf.py -p PORT flash monitor
(Replace PORT with the name of the serial port to use.)
(To exit the serial monitor, type Ctrl-]
.)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
Example Output
After the flashing you should see the output:
I (314) example: USB initialization
I (314) TUSB:descriptors_control: Setting of a descriptor:
.bDeviceClass = 0
.bDeviceSubClass = 0,
.bDeviceProtocol = 0,
.bMaxPacketSize0 = 64,
.idVendor = 0x0000303a,
.idProduct = 0x00004000,
.bcdDevice = 0x00000100,
.iManufacturer = 0x01,
.iProduct = 0x02,
.iSerialNumber = 0x03,
.bNumConfigurations = 0x01
I (344) example: USB initialization DONE
I (354) example: USB task started