![]() see https://devhints.io/semver for syntax |
||
---|---|---|
.. | ||
main | ||
CMakeLists.txt | ||
README.md | ||
sdkconfig.defaults |
README.md
Supported Targets | ESP32 | ESP32-S2 |
---|
Simple example of esp_modem component
(See the README.md file in the upper level 'examples' directory for more information about examples.)
Overview
This example demonstrates the use of the esp-modem component to connect to a network and send some AT commands. It uses modem CMUX mode so that commands and network could be used at the same time.
About the esp_modem
The esp_modem component is deployed automatically when building this example. It will be located inside this example directory, in relative path managed_components/espressif__esp_modem
.
You can find a brief introduction in the root directory of the component, in the main README.md
for or a full html documentation in the relative path docs/html/index.html
.
How to use example
Hardware Required
To run this example, you need an ESP32 dev board connected to a GSM/4G cellular module, which supports AT commands and PPP connectivity. The example uses UART to communicate with the modem and it uses the below pin assignment:
ESP32 | Cellular Modem |
---|---|
GPIO25 | RX |
GPIO26 | TX |
GND | GND |
Configure the project
- Choose the modem module in
Choose supported modem device(DCE)
option. - Set the access point name in
Set Access Point Name(APN)
option, which should depend on the operator of your SIM card. - Enable
EXAMPLE_NEED_SIM_PIN
: To unlock the SIM card with a PIN code if needed
Example Output
The example will unlock the SIM card (if enabled) and enter the CMUX mode. Then it would initiate the connection to a public MQTT broker and at the same time reading some data using AT commands.
I (571) uart: queue free spaces: 30
I (1731) cmux_example: Modem has correctly entered multiplexed command/data mode
I (2241) cmux_example: Operator name: "OperatorName"
I (7781) esp-netif_lwip-ppp: Connected
I (7781) esp-netif_lwip-ppp: Name Server1: xxx.xxx.xxx.xxx
I (7781) esp-netif_lwip-ppp: Name Server2: xxx.xxx.xxx.xxx
I (7781) cmux_example: Got IP address
I (7791) cmux_example: IP : xxx.xxx.xxx.xxx
I (7791) cmux_example: Netmask : xxx.xxx.xxx.xxx
I (7801) cmux_example: Gateway : xxx.xxx.xxx.xxx
I (7801) system_api: Base MAC address is not set
I (7811) system_api: read default base MAC address from EFUSE
I (9061) cmux_example: TOPIC: /topic/esp-modem
I (9061) cmux_example: DATA: Hello modem
I (9061) cmux_example: Data received
I (9211) cmux_example: Modem IMSI number: xxxxxxxxxxxxxxxx
I (21221) esp-netif_lwip-ppp: User interrupt
I (21221) esp_modem_netif: PPP state changed event 5