esp-idf/examples/zigbee/light_sample/light_bulb

Supported Targets	ESP32-H2

Light Bulb Example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

This test code shows how to configure Zigbee router device and use it as a light bulb

Hardware Required

• One development board with ESP32-H2 SoC acting as Zigbee router (loaded with light bulb example)
• A USB cable for power supply and programming
• Choose another ESP32-H2 as Zigbee coordinator (see light coordinator example)
• Choose another ESP32-H2 as Zigbee end-device (see light switch example)

Configure the project

Before project configuration and build, make sure to set the correct chip target using idf.py set-target esp32h2.

Build and Flash

Build the project, flash it to the board, and start the monitor tool to view the serial output by running idf.py -p PORT flash monitor.

(To exit the serial monitor, type Ctrl-].)

Example Output

As you run the example, you will see the following log:

light bulb: I (9638) ESP_ZB_LIGHT: status: 255
I (9638) ESP_ZB_LIGHT: Zigbee stack initialized
I (9648) ESP_ZB_LIGHT: Start network steering
I (12368) ESP_ZB_LIGHT: Joined network successfully (Extended PAN ID: f9:54:2d:01:a0:03:f7:84, PAN ID: 0xf5b5)
I (12398) ESP_ZB_LIGHT: status: 0
I (18158) ESP_ZB_LIGHT: on/off attribute setting to 1
I (19388) ESP_ZB_LIGHT: on/off attribute setting to 0
I (20418) ESP_ZB_LIGHT: on/off attribute setting to 1
I (21558) ESP_ZB_LIGHT: on/off attribute setting to 0
I (22478) ESP_ZB_LIGHT: on/off attribute setting to 1
I (23088) ESP_ZB_LIGHT: on/off attribute setting to 0

Light Control Functions

• By toggling the switch button (BOOT) on the ESP32-H2 board loaded with the light switch example, the LED on this board loaded with light bulb example will be on and off.

Troubleshooting

For any technical queries, please open an issue on GitHub. We will get back to you soon.