![]() |
||
---|---|---|
.. | ||
main | ||
CMakeLists.txt | ||
Makefile | ||
README.md |
README.md
ADC1 Example
(See the README.md file in the upper level 'examples' directory for more information about examples.)
This example shows how to configure ADC1 and read the voltage connected to GPIO pin.
How to use example
Hardware Required
- A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
- A USB cable for power supply and programming
In this example, we use ADC_UNIT_1
by default, we need to connect a voltage source (0 ~ 3.3v) to GPIO34. If another ADC unit is selected in your application, you need to change the GPIO pin (please refer to Chapter 4.11 of the ESP32 Technical Reference Manual
).
Configure the project
make menuconfig
- Set serial port under Serial Flasher Options.
Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
make -j4 flash monitor
(To exit the serial monitor, type Ctrl-]
.)
See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.
Example Output
Running this example, you will see the following log output on the serial monitor:
Raw: 486 Voltage: 189mV
Raw: 435 Voltage: 177mV
Raw: 225 Voltage: 128mV
Raw: 18 Voltage: 79mV
Troubleshooting
-
program upload failure
- Hardware connection is not correct: run
idf.py monitor
, and reboot your board to see if there are any output logs. - The baud rate for downloading is too high: lower your baud rate in the
menuconfig
menu, and try again.
- Hardware connection is not correct: run
For any technical queries, please open an issue on GitHub. We will get back to you soon.