kopia lustrzana https://github.com/espressif/esp-idf
40 wiersze
1.7 KiB
ReStructuredText
40 wiersze
1.7 KiB
ReStructuredText
.. include:: {IDF_TARGET_PATH_NAME}.inc
|
|
:start-after: devkit-defs
|
|
:end-before: ---
|
|
|
|
|
|
Configure {IDF_TARGET_NAME} built-in JTAG Interface
|
|
===================================================
|
|
|
|
{IDF_TARGET_JTAG_PIN_Dneg:default="Not Updated!", esp32c3="GPIO18", esp32s3="GPIO19"}
|
|
{IDF_TARGET_JTAG_PIN_Dpos:default="Not Updated!", esp32c3="GPIO19", esp32s3="GPIO20"}
|
|
|
|
{IDF_TARGET_NAME} has a built-in JTAG circuitry and can be debugged without any additional chip. Only an USB cable connected to the D+/D- pins is necessary. The necessary connections are shown in the following section.
|
|
|
|
Configure Hardware
|
|
^^^^^^^^^^^^^^^^^^
|
|
|
|
.. list-table:: {IDF_TARGET_NAME} pins and USB signals
|
|
:widths: 25 75
|
|
:header-rows: 1
|
|
|
|
* - {IDF_TARGET_NAME} Pin
|
|
- USB Signal
|
|
* - {IDF_TARGET_JTAG_PIN_Dneg}
|
|
- D-
|
|
* - {IDF_TARGET_JTAG_PIN_Dpos}
|
|
- D+
|
|
* - 5V
|
|
- V_BUS
|
|
* - GND
|
|
- Ground
|
|
|
|
Please verify that the {IDF_TARGET_NAME} pins used for USB communication are not connected to some other HW that may disturb the JTAG operation.
|
|
|
|
Configure USB Drivers
|
|
^^^^^^^^^^^^^^^^^^^^^
|
|
|
|
JTAG communication should work on all supported platforms. Windows users might get `LIBUSB_ERROR_NOT_FOUND` errors. Please use version 2.8 (or newer) of the :ref:`get-started-windows-tools-installer` and select the driver "Espressif - WinUSB support for JTAG (ESP32-C3/S3)" in order to resolve this issue. If you don't want to re-run the installer then the same can be achieved with `idf-env <https://github.com/espressif/idf-env>`_ by running the following command from PowerShell::
|
|
|
|
Invoke-WebRequest 'https://dl.espressif.com/dl/idf-env/idf-env.exe' -OutFile .\idf-env.exe; .\idf-env.exe driver install --espressif
|