esp-idf/components/esp_pm/Kconfig

82 wiersze
3.7 KiB
Plaintext

menu "Power Management"
config PM_ENABLE
bool "Support for power management"
default n
help
If enabled, application is compiled with support for power management.
This option has run-time overhead (increased interrupt latency,
longer time to enter idle state), and it also reduces accuracy of
RTOS ticks and timers used for timekeeping.
Enable this option if application uses power management APIs.
config PM_DFS_INIT_AUTO
bool "Enable dynamic frequency scaling (DFS) at startup"
depends on PM_ENABLE
default n
help
If enabled, startup code configures dynamic frequency scaling.
Max CPU frequency is set to DEFAULT_CPU_FREQ_MHZ setting,
min frequency is set to XTAL frequency.
If disabled, DFS will not be active until the application
configures it using esp_pm_configure function.
config PM_USE_RTC_TIMER_REF
bool "Use RTC timer to prevent time drift (EXPERIMENTAL)"
depends on (PM_ENABLE && ESP_TIMER_IMPL_FRC2 && ESP_TIME_FUNCS_USE_RTC_TIMER)
default n
help
When APB clock frequency changes, high-resolution timer (esp_timer)
scale and base value need to be adjusted. Each adjustment may cause
small error, and over time such small errors may cause time drift.
If this option is enabled, RTC timer will be used as a reference to
compensate for the drift.
It is recommended that this option is only used if 32k XTAL is selected
as RTC clock source.
config PM_PROFILING
bool "Enable profiling counters for PM locks"
depends on PM_ENABLE
default n
help
If enabled, esp_pm_* functions will keep track of the amount of time
each of the power management locks has been held, and esp_pm_dump_locks
function will print this information.
This feature can be used to analyze which locks are preventing the chip
from going into a lower power state, and see what time the chip spends
in each power saving mode. This feature does incur some run-time
overhead, so should typically be disabled in production builds.
config PM_TRACE
bool "Enable debug tracing of PM using GPIOs"
depends on PM_ENABLE
default n
help
If enabled, some GPIOs will be used to signal events such as RTOS ticks,
frequency switching, entry/exit from idle state. Refer to pm_trace.c
file for the list of GPIOs.
This feature is intended to be used when analyzing/debugging behavior
of power management implementation, and should be kept disabled in
applications.
config PM_SLP_IRAM_OPT
bool "Put lightsleep related codes in internal RAM"
depends on FREERTOS_USE_TICKLESS_IDLE
default n
help
If enabled, about 1.8KB of lightsleep related codes would be in IRAM and chip would sleep
longer for 760us at most each time.
This feature is intended to be used when a lower power management mode is needed
regardless of the internal memory.
config PM_RTOS_IDLE_OPT
bool "Put RTOS IDLE related codes in internal RAM"
depends on FREERTOS_USE_TICKLESS_IDLE
default n
help
If enabled, about 260B of RTOS_IDLE related codes would be in IRAM and chip would sleep
longer for 40us at most each time.
This feature is intended to be used when a lower power management mode is needed
regardless of the internal memory.
endmenu # "Power Management"