esp-idf/components/esp_rom/include/esp_rom_gpio.h

88 wiersze
2.9 KiB
C

// Copyright 2010-2020 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
//
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
#pragma once
#ifdef __cplusplus
extern "C" {
#endif
#include <stdint.h>
#include <stdbool.h>
#include "soc/gpio_pins.h" //for GPIO_MATRIX_CONST_ONE_INPUT, GPIO_MATRIX_CONST_ZERO_INPUT
/**
* @brief Configure IO Pad as General Purpose IO,
* so that it can be connected to internal Matrix,
* then combined with one or more peripheral signals.
*
* @param iopad_num IO Pad number
*/
void esp_rom_gpio_pad_select_gpio(uint32_t iopad_num);
/**
* @brief Enable internal pull up, and disable internal pull down.
*
* @param iopad_num IO Pad number
*/
void esp_rom_gpio_pad_pullup_only(uint32_t iopad_num);
/**
* @brief Unhold the IO Pad.
* @note When the Pad is set to hold, the state is latched at that moment and won't get changed.
*
* @param iopad_num IP Pad number
*/
void esp_rom_gpio_pad_unhold(uint32_t gpio_num);
/**
* @brief Set IO Pad current drive capability.
*
* @param iopad_num IO Pad number
* @param drv Numeric to indicate the capability of current drive
* - 0: 5mA
* - 1: 10mA
* - 2: 20mA
* - 3: 40mA
*/
void esp_rom_gpio_pad_set_drv(uint32_t iopad_num, uint32_t drv);
/**
* @brief Combine a GPIO input with a peripheral signal, which tagged as input attribute.
*
* @note There's no limitation on the number of signals that a GPIO can combine with.
*
* @param gpio_num GPIO number, especially, `GPIO_MATRIX_CONST_ZERO_INPUT` means connect logic 0 to signal
* `GPIO_MATRIX_CONST_ONE_INPUT` means connect logic 1 to signal
* @param signal_idx Peripheral signal index (tagged as input attribute)
* @param inv Whether the GPIO input to be inverted or not
*/
void esp_rom_gpio_connect_in_signal(uint32_t gpio_num, uint32_t signal_idx, bool inv);
/**
* @brief Combine a peripheral signal which tagged as output attribute with a GPIO.
*
* @note There's no limitation on the number of signals that a GPIO can combine with.
*
* @param gpio_num GPIO number
* @param signal_idx Peripheral signal index (tagged as output attribute)
* @param out_inv Whether to signal to be inverted or not
* @param oen_inv Whether the output enable control is inverted or not
*/
void esp_rom_gpio_connect_out_signal(uint32_t gpio_num, uint32_t signal_idx, bool out_inv, bool oen_inv);
#ifdef __cplusplus
}
#endif