|
…
|
||
|---|---|---|
| .. | ||
| main | ||
| CMakeLists.txt | ||
| README.md | ||
| partitions.csv | ||
| sdkconfig.defaults | ||
README.md
| Supported Targets | ESP32-H2 |
|---|
Light Coordinator Example
(See the README.md file in the upper level 'examples' directory for more information about examples.)
This test code shows how to configure Zigbee coordinator device.
Hardware Required
- One development board with ESP32-H2 SoC acting as Zigbee coordinator (loaded with light coordinator example)
- A USB cable for power supply and programming
- Choose another ESP32-H2 as Zigbee router (see light bulb example)
- Choose another ESP32-H2 as Zigbee end-device (see light switch example)
Configure the project
Before project configuration and build, make sure to set the correct chip target using idf.py set-target esp32h2.
Build and Flash
Build the project, flash it to the board, and start the monitor tool to view the serial output by running idf.py -p PORT flash monitor.
(To exit the serial monitor, type Ctrl-].)
Example Output
As you run the example, you will see the following log:
light coodrinator:
I (9556) ESP_ZB_COORDINATOR: status: -1
I (9556) ESP_ZB_COORDINATOR: Zigbee stack initialized
I (9556) ESP_ZB_COORDINATOR: Start network formation
I (10066) ESP_ZB_COORDINATOR: Joined network successfully (Extended PAN ID: f9:54:2d:01:a0:03:f7:84, PAN ID: 0xf5b5)
I (10526) ESP_ZB_COORDINATOR: Network steering started
I (11306) ESP_ZB_COORDINATOR: status: 0
I (11806) ESP_ZB_COORDINATOR: status: 0
I (11886) ESP_ZB_COORDINATOR: New device commissioned or rejoined (short: 0x434a)
I (12386) ESP_ZB_COORDINATOR: status: 0
I (12486) ESP_ZB_COORDINATOR: status: 0
I (12896) ESP_ZB_COORDINATOR: status: 0
I (12946) ESP_ZB_COORDINATOR: New device commissioned or rejoined (short: 0x09c2)
I (13516) ESP_ZB_COORDINATOR: status: 0
I (26686) ESP_ZB_COORDINATOR: status: 0
Light Control Functions
- By toggling the switch button (BOOT) on the ESP32-H2 board loaded with
light switchexample, the LED on the board loaded withlight bulbexample will be on and off.
Troubleshooting
For any technical queries, please open an issue on GitHub. We will get back to you soon.