menu "Example Configuration" config EXAMPLE_TOUCH_WAKEUP bool "Enable touch wake up" default y depends on !IDF_TARGET_ESP32C3 help This option enables wake up from deep sleep using touch pads TOUCH8 and TOUCH9, which correspond to GPIO33 and GPIO32. config EXAMPLE_ULP_TEMPERATURE_WAKEUP bool "Enable temperature monitoring by ULP" default y depends on IDF_TARGET_ESP32 help This option enables wake up from deep sleep using ULP. ULP program monitors the on-chip temperature sensor and wakes up the chip when the temperature goes outside of the window defined by the initial temperature and a threshold around it. config EXAMPLE_EXT1_WAKEUP bool "Enable wakeup from GPIO" default y depends on !IDF_TARGET_ESP32C3 help This option enables wake up from deep sleep from GPIO2 and GPIO4. They should be connected to LOW to avoid floating pins. When triggering a wake up, connect one or both of the pins to HIGH. Note that floating pins may trigger a wake up. config EXAMPLE_GPIO_WAKEUP bool "Enable wakeup from GPIO" default y depends on IDF_TARGET_ESP32C3 help This option enables wake up from GPIO, only GPIO0~5 can be used to wake up. Be aware that if you use low level to trigger wakeup, we strongly recommand you to connect external pull-up resistance. menu "GPIO wakeup configuration" visible if IDF_TARGET_ESP32C3 config EXAMPLE_GPIO_WAKEUP_PIN int "Enable wakeup from GPIO" default 0 range 0 5 config EXAMPLE_GPIO_WAKEUP_HIGH_LEVEL bool "Enable GPIO high-level wakeup" default y help This option set the gpio wake-up trigger signal, In deep sleep, only high or low level wake-up is supported. If this option is enabled, it is a high level wake up, otherwise it is a low level wake up. endmenu endmenu