This commit updates updates the LLs of USB WRAP and USJ as follows:
- Added missing 'usb_wrap_ll.h' and 'usb_serial_jtag_ll.h' for the ESP32-P4
- Added LL cap macros to distinguish feature differences between the LLs of
different targets:
- '..._LL_EXT_PHY_SUPPORTED' indicates whether the USB WRAP/USJ supports
routing to an external FSLS PHY.
- '..._LL_SWAP_PHY_SUPPORTED' indicates whether the USB WRAP/USJ supports
swapping between multiple internal FSLS PHYs.
- Tidied up some RCC LL functions and their callers.
- Added 'usb_wrap_types.h' and 'usb_serial_jtag_types.h' to provide types used
in LLs.
- Fixed some spelling/naming issues as part of code-spell pre-commit
For targets that only contain a USJ peripheral (and not a DWC OTG), their
'usb_fsls_phy_ll.h' headers only contain a single function
('usb_fsls_phy_ll_int_jtag_enable()') whose feature is already covered by
functions in 'usb_serial_jtag_ll.h'. Thus, this header is redundant.
This commit does the following:
- Remove 'usb_fsls_phy_ll.h' for targets that only contain a USJ peripheral
- Rename 'usb_fsls_phy_[hal|ll].[h|c]' to `usb_wrap_[hal|ll].[h|c]` for targets
that contain a DWC OTG peripheral. This better reflects the underlying peripheral
that the LL header accesses.
If the TimerGroup 0 clock is disabled and then reenabled, the watchdog
registers (Flashboot protection included) will be re-enabled, and some
seconds later, will trigger an unintended reset.
Signed-off-by: Gustavo Henrique Nihei <gustavo.nihei@espressif.com>
This commit marks all functions in interrupt_controller_hal.h, cpu_ll.h and cpu_hal.h as deprecated.
Users should use functions from esp_cpu.h instead.
1. Rename MACROs SYSTEM_WIFI_RST_EN register bit fields to be more recognizable
2. reset Bluetooth baseband and clock bits to fix the issue of task watchdog triggered during controller initialization due to invalid hardware state
Moved the following kconfig options out of the target component:
* CONFIG_ESP*_DEFAULT_CPU_FREQ* -> esp_system
* ESP*_REV_MIN -> esp_hw_support
* ESP*_TIME_SYSCALL -> newlib
* ESP*_RTC_* -> esp_hw_support
Where applicable these target specific konfig names were merged into
a single common config, e.g;
CONFIG_ESP*_DEFAULT_CPU_FREQ -> CONFIG_ESP_DEFAULT_CPU_FREQ_MHZ
peripheral enable/disable usually should be managed by driver itself,
so make it as espressif private APIs, not recommended for user to use it
in application code.
However, if user want to re-write the driver or ports to other platform,
this is still possible by including the header in this way:
"esp_private/peripheral_ctrl.h"
Darian Leung