esp-idf/examples/system/ulp_adc/README.md

45 wiersze
1.2 KiB
Markdown
Czysty Zwykły widok Historia

2017-04-20 08:13:09 +00:00
# ULP ADC Example
This example demonstrates how to use the ULP coprocessor to poll ADC in deep sleep.
ULP program periodically measures the input voltage on GPIO34. The voltage is compared to two thresholds. If the voltage is less than the low threshold, or higher than the high threshold, ULP wakes up the system.
By default, thresholds are set to 1.35V and 1.75V, approximately.
GPIO15 is connected to ground to supress output from ROM bootloader.
Average current drawn by the ESP32 in this example (with the default 4x averaging) depending on the measurement frequency is as follows:
Measurement frequency, Hz | Average current, uA
--------------------------|---------------------
10 | 8.5
50 | 20
100 | 37
2017-04-20 08:13:09 +00:00
## Example output
Below is the output from this example.
2017-04-20 08:13:09 +00:00
```
Not ULP wakeup
Entering deep sleep
Deep sleep wakeup
ULP did 1531 measurements
Thresholds: low=1500 high=2000
Value=973 was below threshold
Entering deep sleep
Deep sleep wakeup
ULP did 2 measurements
Thresholds: low=1500 high=2000
Value=0 was below threshold
Entering deep sleep
Deep sleep wakeup
ULP did 2 measurements
Thresholds: low=1500 high=2000
Value=0 was below threshold
Entering deep sleep
```