WLED/usermods/EleksTube_IPS/User_Setup.h

48 wiersze
1.8 KiB
C

/*
* This is intended to over-ride `User_Setup.h` that comes with the TFT_eSPI library.
* I hate having to modify the library code.
*/
// ST7789 135 x 240 display with no chip select line
#define ST7789_DRIVER // Configure all registers
#define TFT_WIDTH 135
#define TFT_HEIGHT 240
#define CGRAM_OFFSET // Library will add offsets required
//#define TFT_RGB_ORDER TFT_RGB // Colour order Red-Green-Blue
//#define TFT_RGB_ORDER TFT_BGR // Colour order Blue-Green-Red
//#define TFT_INVERSION_ON
//#define TFT_INVERSION_OFF
// EleksTube IPS
#define TFT_SDA_READ // Read and write on the MOSI/SDA pin, no separate MISO pin
#define TFT_MOSI 23
#define TFT_SCLK 18
//#define TFT_CS -1 // Not connected
#define TFT_DC 25 // Data Command, aka Register Select or RS
#define TFT_RST 26 // Connect reset to ensure display initialises
#define LOAD_GLCD // Font 1. Original Adafruit 8 pixel font needs ~1820 bytes in FLASH
//#define LOAD_FONT2 // Font 2. Small 16 pixel high font, needs ~3534 bytes in FLASH, 96 characters
//#define LOAD_FONT4 // Font 4. Medium 26 pixel high font, needs ~5848 bytes in FLASH, 96 characters
//#define LOAD_FONT6 // Font 6. Large 48 pixel font, needs ~2666 bytes in FLASH, only characters 1234567890:-.apm
//#define LOAD_FONT7 // Font 7. 7 segment 48 pixel font, needs ~2438 bytes in FLASH, only characters 1234567890:.
//#define LOAD_FONT8 // Font 8. Large 75 pixel font needs ~3256 bytes in FLASH, only characters 1234567890:-.
//#define LOAD_FONT8N // Font 8. Alternative to Font 8 above, slightly narrower, so 3 digits fit a 160 pixel TFT
//#define LOAD_GFXFF // FreeFonts. Include access to the 48 Adafruit_GFX free fonts FF1 to FF48 and custom fonts
//#define SMOOTH_FONT
//#define SPI_FREQUENCY 27000000
#define SPI_FREQUENCY 40000000
/*
* To make the Library not over-write all this:
*/
#define USER_SETUP_LOADED