kopia lustrzana https://github.com/Aircoookie/WLED
36 wiersze
1.6 KiB
Markdown
36 wiersze
1.6 KiB
Markdown
# Controlling Wiz lights
|
|
|
|
Enables controlling [WiZ](https://www.wizconnected.com/en/consumer/) lights that are part of the same network as the WLED controller.
|
|
|
|
The mod takes the colors from the first few pixels and sends them to the lights.
|
|
|
|
## Configuration
|
|
|
|
- Interval (ms)
|
|
- How frequently to update the WiZ lights, in milliseconds.
|
|
- Setting it too low may cause the ESP to become unresponsive.
|
|
- Send Delay (ms)
|
|
- An optional millisecond delay after updating each WiZ light.
|
|
- Can help smooth out effects when using a large number of WiZ lights
|
|
- Use Enhanced White
|
|
- Uses the WiZ lights onboard white LEDs instead of sending maximum RGB values.
|
|
- Tunable with warm and cool LEDs as supported by WiZ bulbs
|
|
- Note: Only sent when max RGB value is set, the automatic brightness limiter must be disabled
|
|
- ToDo: Have better logic for white value mixing to take advantage of the light's capabilities
|
|
- Always Force Update
|
|
- Can be enabled to always send update message to light even if the new value matches the old value.
|
|
- Force update every x minutes
|
|
- adjusts the default force update timeout of 5 minutes.
|
|
- Setting to 0 is the same as enabling Always Force Update
|
|
-
|
|
Next, enter the IP addresses for the lights to be controlled, in order. The limit is 15 devices, but that number
|
|
can be easily changed by updating _MAX_WIZ_LIGHTS_.
|
|
|
|
|
|
|
|
|
|
## Related project
|
|
|
|
If you use these lights and python, make sure to check out the [pywizlight](https://github.com/sbidy/pywizlight) project. You can learn how to
|
|
format the messages to control the lights from that project.
|