LED & Hardware setup

Total LEDs: ?
Recommended power supply for brightest white:
?
Enable automatic brightness limiter:
Automatically limits brightness to stay close to the limit.
Keep at <1A if poweing LEDs directly from the ESP 5V pin!
Analog (PWM) and virtual LEDs cannot use automatic brightness limiter.
Maximum PSU Current: mA
Use per-output limiter:

Hardware setup

LED outputs:

LED Memory Usage: 0 / ? B

Make a segment for each output:
Custom bus start indices:
Use global LED buffer:
Color Order Override:

Disable internal pull-up/down:
Touch threshold:
IR GPIO:  ✕
Apply IR change to main segment only:
IR info
Relay GPIO:  ✕ Invert Open drain

Defaults

Turn LEDs on after power up/reset:
Default brightness: (0-255)

Apply preset at boot (0 uses defaults)

Use Gamma correction for color: (strongly recommended)
Use Gamma correction for brightness: (not recommended)
Use Gamma value:

Brightness factor: %

Transitions

Enable transitions:
Effect blending:
Transition Time: ms
Palette transitions:
Random Cycle Palette Time: s
Use harmonic Random Cycle Palette:

Timed light

Default Duration: min
Default Target brightness:
Mode:

White management

White Balance correction:
Global override for Auto-calculate white:

Calculate CCT from RGB:
CCT IC used (Athom 15W):
CCT additive blending: %

Advanced

Palette blending:
Target refresh rate: FPS
Config template: